Crestron FlipTop FT2 Series Panduan Memulai Cepat - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Sistem Kontrol Crestron FlipTop FT2 Series. Crestron FlipTop FT2 Series 9 halaman. Ac power outlet modules
Juga untuk Crestron FlipTop FT2 Series: Mulai Cepat (2 halaman), Mulai Cepat (2 halaman), Panduan Memulai Cepat (11 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (11 halaman), Panduan Memulai Cepat (9 halaman), Panduan Memulai Cepat (11 halaman), Memulai (2 halaman), Memulai (2 halaman), Memulai (2 halaman), Manual (2 halaman), Manual (2 halaman), Manual (2 halaman), Panduan Memulai Cepat (7 halaman), Panduan Memulai Cepat (8 halaman), Mulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman), Mulai Cepat (2 halaman), Mulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman), Mulai Cepat (2 halaman), Mulai Cepat (2 halaman)

FT2-1200-ELEC-PTL

FlipTop™ FT2 Series Cable Management System, 1200 Size, Electrical, Pass-Through Lid

3. Attach the side plate to the module by snapping the plastic clips on

the plate into the two slots on the module.

NOTE:

When removing the side plate, use a flat-head screwdriver to

carefully pry the plastic clips off of the module near the two slots.

4. Feed the other end of the cable through an empty module slot in the

FT2 assembly.

5. Slide the pass-through cable module into the same module slot as

mentioned in the previous step. Use the guide ribs on the front and

rear of each module to help position the module in the FT2 assembly.

Installing the Pass-Through Cable Module with Non-4K

Cables

The grommet is recommended to use with cables that are 10 mm or

thinner.

1. Open the grommet.

2. Insert a cable into the grommet with the connector facing up toward

the user.

3. Press the grommet back together to secure the cable inside.

4. Push the grommet and cable through the hole in the cable plate.

5. Insert the cable plate into one of the three slots in the pass-through

module. Choose the appropriate slot based on the length of the cable

connector. The top of the connector must sit flush with the top of the

module.

NOTES:

If the connector extends past the top of the pass-through

module, the lid cannot close.

Ensure that the cable moves freely in the module prior to

attaching the side plate. The plate is difficult to remove once it is

attached.

Quick Start