Actron 615 Panduan Pemilik - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Alat Ukur Actron 615. Actron 615 8 halaman. Engine analyzer

POINTS- LOW

VOLTAGE

SCALE

The POINTS scale is also a 0-1.0 volt scale.

This scale-is useful for checking voltage drops

in the vehicle's electrical system.

SOLENOID

CONNECTION

STARTER

CONNECTION

BATTERY

CONNECTICN

Set the slide switch knob to OTHER TESTS and

the Function Selector Knob to POINTS.

Use

the GREEN and BLACK clips for these tests.

The RED clip is not used.

Corroded or loose connections and frayed or bro-

ken cables can cause excessive voltage drops in

the starting circuit which can cause hard starting.

To test for these conditions, connect the clips be-

tween I and 2, 2 and 3, 4 and 5, 5 and 6, 6 and

7, 7 and 8 with the starter turning.

During this

test, no reading should be higher than .1 volt.

If a reading higher than .1 volt is observed during

any of these tests, check the cable or connections

involved, clean and tighten the connections and

replace the cables or solenoid when necessary. If

the meter reads to the left of zero during any of

the above tests, reverse the position of the clips.