Digital Check TELLERSCAN TSX40 Panduan Instalasi Mudah
Jelajahi secara online atau unduh pdf Panduan Instalasi Mudah untuk Pemindai Digital Check TELLERSCAN TSX40. Digital Check TELLERSCAN TSX40 2 halaman.
Halaman CetakTellerScan
What's Included
▪ TellerScan TSX40 scanner
▪ Power supply with electrical supply cord
▪ USB 2.0 cable
▪ Ink cartridge
● Note: Only 'Inkjet' model scanners are
supplied with an ink cartridge.
TSX40 Easy Installation Guide
®
Installing the Ink Cartridge
● Open the center cover by pressing the latch,
and lifting the cover off the scanner.
● Open the ink cartridge package and remove
the protective seal.
● Insert the nozzle end of the cartridge into the
platform while keeping the end of the cartridge
tilted slightly upward. Then, push down on the
rear of the cartridge until it 'clicks' or snaps
securely into position.
Important: The top of the cartridge should
appear level or flat when it is fully seated.
Find further instructions for installing the inkjet
cartridge at digitalcheck.com/tsx40operation.
www.digitalcheck.com
● Note: Digital Check does not provide the
required device drivers or scanning software.
Please contact your bank, IT department or
other solution provider for further assistance
with installing the driver or getting the scanning
software set up or installed.
● Install the device driver / software before
connecting the USB cable to the scanner.
● When connecting the scanner, plug the power
supply into the scanner first, then into an outlet.
● Connect the USB cable by inserting the
square USB-B plug into the scanner and the flat
USB-A plug into a rear USB port on the PC.
● Place the scanner and the included Digital
Check branded power supply 6-12 inches away
from other electronic devices. (small desk fans,
other device power supplies, pneumatic tubes
at the teller window etc.)
Secure the
Center Cover
Power Connector Port
Rev C_05262023
Getting Started
USB Port