Digital Control DigiTrack Falcon F1 Panduan Memulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Peralatan Industri Digital Control DigiTrack Falcon F1. Digital Control DigiTrack Falcon F1 6 halaman.

Halaman Cetak

To access the AGR screen later, select

wait 15 seconds for the AGR screen.

Settings Menu

Settings

Use the

telemetry channel. Set the remote display to match receiver depth and

pitch settings.

Height-Above-Ground (HAG) Menu

HAG is the distance from the ground to the base of the receiver while it is

held. Setting HAG on the Main menu lets you take accurate below-ground

depth measurements without having to place the receiver on the ground.

Max Mode

Max Mode helps obtain depth/data readings in high-interference areas

when readings are unstable.

The drill head must remain still during Max Mode readings.

Hold the trigger at least five seconds to enter Max Mode. Do not

consider the data useful unless the reading is stable before the Max

Mode timer is full.

Always take three Max Mode readings; all must be consistent.

See the system operator's manual for additional important information on

the use of this feature.

Signal Attenuation

icon may appear on the roll indicator and FO results when the

receiver is attenuating the Tx signal for depths shallower than 8 ft. This is

normal. See the operator's manual if the signal strength is flashing,

indicating extreme interference.

menu to set the depth units, pitch units, roll offset, and

Watch our DigiTrak

www.YouTube.com/DCIKent

Calibration

1PT CAL

training videos at

- 4 -

, and

Printed:

10/9/2018