DIGITAL DELAY Mega 50 Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Unit Kontrol DIGITAL DELAY Mega 50. DIGITAL DELAY Mega 50 9 halaman. W/ 4 stage timer

Features:

• Microprocessor controlled timing

• Discrete I/O (input - output) construction

• Retains all numbers even with power disconnected from unit

• Large illuminated display for easy reading of information day or night

• Self-test mode on all display functions

• Dust & splash-proof keypad with detent (positive feel)

• Hit the tree twice with one or two separate button

• Instant timing cycle reset

• Programmable push-button interrupt time

• Programmable Tap Up/Down feature for the delay (In pushbutton mode 1 or 3)

• Programmable Starting Line Enhancer (MEGA 75 w/ 4 Stage Timer only)

• Built-in drivers reaction tester

Specifications:

• Input Voltage Range: 10 to 18 Volts DC (16 Volt compatible)

• Operating Temperature Range: 0 to 150 degrees F.

• Push-button Current: .1 AMPS at 12 VDC

• Two Separate Inputs

• P.B. 1

• P.B. 2 or Tap P.B.

+12VDC Terminal:

capable of driving all outputs at the same time.

Transbrake Terminal:

Connect the low side of the 2-Step here, if used.

Ground Terminal:

ground, not aluminum.

PB-1 Terminal:

In Push-button Mode 3 the push-button connected to PB-1 terminal is used

to control the primary delay and the secondary delay in sequence. In Push-button Mode 1 & 2

the push-button connected to PB-1 terminal is used to control the primary delay only.

PB-2 Terminal:

In Push-button Mode 2 the push-button connected to PB-2 terminal is

used to control the secondary delay only. In Push-button Mode 1 & 3 this terminal can be used for a Tap

pushbutton connection. After a Transbrake push-button has been released, every time the Tap push-button is

depressed a programmable amount of time is either added to, or subtracted from, the first delay time started until the

transbrake is released.

Throttle Stop Terminal:

starting line enhancer or down track throttle stop controller. This is only on the MEGA 75 w/ 4 Stage Timer.

Features and Specifications

Connect the +12VDC terminal to a switched +12 Volt source with enough amperage

Connect the Transbrake terminal to the Transbrake solenoid.

Connect the Ground terminal to the Neg. terminal on the battery or to good steel

Connect throttle stop wire to this terminal. This can be used as a