DIGITAL DELAY REPLAY TACH Petunjuk Manual - Halaman 6
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Unit Kontrol DIGITAL DELAY REPLAY TACH. DIGITAL DELAY REPLAY TACH 9 halaman.
Halaman CetakWhile display shows (Record length XX)
While display shows (Shift output = XX)
_____________________________________________________________________________________________________
The help screens can be turned on and off in the setup modes screen. When turned on, every time a button is pressed
the Replay Tach with RPM Switch will cycle through three screens of text. Each of the three help screens will be displayed
for about 1 ½ second and will have a brief explanation of the current screen you have selected.
The data lock can be turned on and off in the setup modes screen or by holding down the menu button until the data
lock screen is displayed. When turned on, with the exception of the data lock setting (none of the settings in the Replay Tach
with RPM Switch can be changed). This is to keep the settings in the unit from getting changed by accidentally hitting the
buttons.
The Number of Cylinders is set under the setup modes screen and can be set to 4, 6, or 8 cylinders. This setting must
match the number of cylinders the engine has for proper operation.
The Replay Tach with RPM Switch can handle up to five shifts on each pass. The five shifts can each be set to a
different RPM shift point. The shifts occur in sequence 1 through 5, once the engine RPM is higher than the reset RPM
setting. The reset RPM setting and the fall RPM are found in the Setup Mode screens, while the shift points can be viewed and
adjusted in the Shifts screens.
The Fall RPM is changed under the setup modes screen and can be set to 50, 100, 150, or 200 RPM. The fall RPM is
used to control how far the engine must fall below a shift point to complete the shift. In most cases the 50 RPM setting will
work the best, however in some vehicles that are shifting more than once this value may need to be increased to keep the
shifter from double cycling.
The Reset RPM is changed under the setup modes screen and can be set from 1500 RPM to 3000 RPM in 50 RPM
increments. When the engine RPM is below the reset RPM the shifting circuit is turned off and the pushbuttons on the Replay
Tach with RPM Switch are enabled. Also the shift sequence is reset to shift number one. When the engine RPM then rises
above the reset RPM the Replay Tach with RPM Switch buttons are disabled and the shift circuit is turned on and starts
looking for the first shift. When the engine RPM reaches the first shift point the shift terminal will activate and stay activated
until the engine RPM falls below the shift point minus, the fall RPM the unit will then start looking for the next shift. In the
event the next shift point is lower than the previous shift point minus the fall RPM, the engine will have to fall below the new
shift point before the unit will start looking for the new shift point.
Menu button
Moves to shift output = XX.
Change button
N/A
Exit button
Moves back to the setup modes screen.
Up Arrow
Sets record length to either 15 or 30 seconds.
Down Arrow
N/A
Menu button
Moves to help screens XXX.
Change button
N/A
Exit button
Moves back to the setup modes screen.
Up Arrow
Toggles shift output HI/LO.
Down Arrow
N/A
The Help Screens
The Data Lock
Number of Cylinders
Fall RPM, Reset RPM,
and Shift Output Mode
6