DIGITAL DELAY 1020-SCR Petunjuk Manual - Halaman 6
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Panel Kontrol DIGITAL DELAY 1020-SCR. DIGITAL DELAY 1020-SCR 10 halaman.
Halaman Cetak
The display on the Crossover Plus is used to display all of the information that is stored in
memory, as well as information entered on the keypad. There are eight red L.E.D.s to the left of the key
pad. Starting from the top and going down the text that is to the right of the last lit L.E.D. corresponds to
the information being shown on the display. For example if the last L.E.D. lit is next to the text "How
Late" (#5) the Display would be showing the How Late information.
Other special functions of the display are:
Low Voltage Indication:
when voltage to the unit is below the recommended minimum of
11.5 Volts.
Transbrake-Colons:
will turn on. When the delay timer starts counting down the
colon will flash.
Recovery Arrow:
displayed, and the arrow is shown the Recovery is on. If the
arrow is not being displayed the Recovery is off.
Tap Arrow:
When the Tap information is being displayed and
the arrow is shown, the unit is set in tap up mode. If the arrow is
not shown the unit is in tap down mode.
Decimal Point:
the correct position for the time displayed. When displaying Tap
Control or Push Button mode information the decimal point will not
be displayed.
The Display
The numbers on the display will flash
When the transbrake is engaged the colon
When the Recovery information is being
When displaying times, the decimal point will move to
6