Digital Design M2b Panduan Pemilik - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Digital Design M2b. Digital Design M2b 12 halaman. High performance digital amplifier
Halaman Cetak
REMOTE LEVEL CONTROL PORT
This port is for connecting turn-down remote level control.
Remote level control adjusts the level
LPF CROSSOVER FREQUENCY
Controls the low pass point for the speaker outputs.
The crossover range is 20~200Hz @ 24dB/Oct Slope
OUTPUT MASTER / INPUT SLAVE
OUTPUT MASTER / INPUT SLAVE connection makes same M-Class
models as daisy chain connection to 2 ohm.
Minimum working impedance in the use of daisy chain connect is 2 ohm.
GND (GROUND CONNECTION )
It is connected to the Negative or ground cables of the Vehicle.
Recommended cable is 4 ga for SSlb, M lc and 0 ga for M2b
REM ( REMOTE)
It is connected to switched
+
12V with a Trigger cable coming from
the head unit
3-2. CONTROL & CONNECTION FOR FULL RANGE DIGITAL MULTI-CHANNELS
REMOTE CONTROL
If you turn knob to dock-wise ( Min ), it reduces Level.
If you turn knob to counter clock-wise ( Max ), it is maximum level position.
Clipping LED shows the clipping point of The M-Class amplifiers.
When The M-Class amplifiers are close to clipping point, Clipping LED is
starting to clip.
When Clipping LED is clipping faster, it is better to turn level down.
If Clipping LED is lit on, Amplifier is protected.
The M-Class amplifiers will be on in few minutes later.
+ 12V ( POWER CONNECTION )
This must be connected to the fuse positive terminal ( + 12V) of the battery.
Recommended wire is 4 ga for SSlb, M lc and 0 ga for M2b
SPEAKER OUTPUTS
it connects amplifier to speakers. Minimum speaker cable is 12 gauge.
Minimum impedance for single unit is 1 ohm.
Minimum impedance in linked use is 2 ohm.