Digital Electronics FP790-T21 Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Monitor Digital Electronics FP790-T21. Digital Electronics FP790-T21 17 halaman. Flat panel display

Halaman Cetak

The FP79*-2* units are CE marked, EMC compliant products.

• Safety

EN60950

• EMI (EN50081-2)

EN55011 group1 (Class A)

• EMS (EN61000-6-2)

EN61000-4-2, EN61000-4-3, EN61000-4-4, EN61000-4-5, EN61000-4-6,

EN61000-4-8, ENV50204

If the following requirements are not met, the FP may fail to meet EN60950

standard requirements.

• The FP must be used as a built-in component of an end-use product.

• Use the FP indoors only.

• When connecting the FP's power cable, be sure to use a cable that is appropriate

for the current and voltage used and that has conductive wires that are 0.75 mm

larger.

• When using the FP in an end-use product, be sure to install the FP unit's power cut-

off switch where the operator can easily reach it.

• There is a danger of explosion if the backup battery is incorrectly replaced. This

battery should be replaced only with same or equivalent type recommended by the

manufacturer. Dispose of used batteries according to the manufacturer's instructions.

• Be sure the FP unit's enclosure is an EN60950 approved sheet steel structure.

The FP package should include the following items:

FP Unit

(FP790-T21)

Installation Gasket

These items have all been carefully packed with special attention to product quality. However,

should you find any item(s) damaged or missing, please contact your FP distributor immediately

for prompt service.

*1 For a description and usage of the application programs stored in the CD-ROM, see the

"READM_E.DOC" file.

CE Marking Notes

Package Contents

Installation Guide

(This document)

FP790-T21

Installation

Guide

Installation Brackets (12)

- 2 -

CD-ROM (1)

(Contains the FP User

Manual's PDF file.)