Bits Limited SCG3 Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pelindung Lonjakan Arus Bits Limited SCG3. Bits Limited SCG3 3 halaman.

2&*$344%&'($)#("135$("$5%6

Power Switch: This Lighted switch is also a 15 amp circuit breaker. It is normally left

on. If it's not lit, turn it on, reset it or try a different outlet.

Switched Outlets Indicator: When lit, this indicates that the switched outlets are on.

Ground & Surge Indicator: When this is lit, your equipment is protected.

If it's not, it might be:

1. A bad or unavailable ground, use another outlet.

2. The surge protection has failed; check http://bitsltd.net/FAQ, or call us.

Control Outlet: Plug your TV or computer here.

This outlet controls the SWITCHED OUTLETS; if the device plugged in here is on, they

are on. If off, they are off.

Constant Hot Outlets: Plug your Cable box, satellite receiver, DVR, fax or cable

modem here. These outlets will only turn off with the power switch.

Automatically Switched Outlets: Plug in all of your other accessories here.

These will turn on or off with the device plugged in the CONTROL OUTLET

automatically. So when the device in the control outlet is off, everyting here is

unplugged & saving you energy.

"#$$%&'($)#("#&*%$%+%$,(-./0*$1#&$

You may need to adjust the Smart Strip's sensitivity. Fortunately, it's easy to calibrate,

by using a finger nail, small screwdriver or butter knife.

If the switched outlets never turn on:

1. Turn on the device that is plugged into the CONTROL OUTLET.

2. Turn the dial slowly clockwise until the SWITCHED OUTLETS turn on.

3. Turn off the device in the control outlet; if the SWITCHED OUTLETS are off, you're

done.

If the switched outlets never turn off:

1. Turn off the device that is plugged into the CONTROL OUTLET.

2. Turn the dial slowly counterclockwise until the SWITCHED OUTLETS turn off.

3. Turn on the device that is on the CONTROL OUTLET; if the SWITCHED OUTLETS

are on, you're done.

Important Notes:

!"#$%"&'()*+,%-+"'.&/".*"0-/1"&"2"+)3-"'.&/4"5/%&*%"'0"-0+"6037%".+8

!"96"+$%"&:0;%"5307%')3%"'0%*"-0+"<03=>"5/%&*%"70-+&7+")*8

!"?0,%"70,5)+%3*"7&-"+&=%"@AB",.-)+%*":%603%"+$%1"*/%%5"03"$.:%3-&+%>"+$.*",&1"%66%7+

how you calibrate your Smart Strip. When finally it does, everything turns off.

!"C.*="06"%/%7+3.7"*$07=8"D0"-0+"5/)E".-+0"&-0+$%3"3%/07&+&:/%"50<%3"+&58

The 3rd Generation Smart Strip works with the following devices in the control outlet:

!"F//"70,5)+%3*"G"$0,%"%-+%3+&.-,%-+"%H).5,%-+

!"F//"<03=*$05"%H).5,%-+

!"@I"J&++"03"E3%&+%3".-7&-'%*7%-+"/&,5*

!"I"J&++"03"E3%&+%3"6/)03%*7%-+"/&,5*

If you have any questions please visit our web site 1st since we have an extensive

knowledge base which mostly will answer your question.