Bitspower BP-DIO240-TBBK Panduan Instalasi - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Perangkat Keras Komputer Bitspower BP-DIO240-TBBK. Bitspower BP-DIO240-TBBK 15 halaman.
Halaman Cetak
3
Install the CPU
Apply block over Intel CPU
G
Before use, please make sure that the motherboard
you choose has DRGB (Digital RGB) lighting effect and
its appropriate connector, usually 3PIN. Or you can
DRGB LED
also
use
BPTA-DRGBMFC.
4
Connect the RGB light effect wire
BPTA-HUB-RGB
8
When using the hub board for DRGB lighting, please cut off the excess PIN pin
as indicated on the picture.
Note: The hub board main purpose is to group all RGB connectors together
for easy cable management. This hub has no lighting effect control function.
OUT
IN
Bitspower's
lighting
controller
Intel socket 2011 CPU water block installation
Use an appropriate amount
of thermal paste.
Intel socket 775/115x CPU water block installation
-
P 7
SCM3F
SPRING
1 MM WASHER
Screw for Intel 2011 socket
Thumb screw
SPRING
1mm WASHER
The thumb screw cannot
be locked too tightly, the
SCM3F6 screw
spring is slightly pressed
1mm WASHER
and the gap is kept as
Use an appropriate
shown below. The thumb
amount of thermal
screw cannot be rotated
paste.
to the end. When the
spring screws too tight,
the SCM3F6 screw will be
driven and will be taken
away from the mother-
board, which will cause
the water block and CPU
not to be closed well.
SILICONE PAD
BACKPLANE PASTE PAD
METAL BACKPLANE
M3x32mm SCREW
V3