Digital Equipment DEC 3000 300 AXP Series Menyiapkan Sistem Anda - Halaman 8

Jelajahi secara online atau unduh pdf Menyiapkan Sistem Anda untuk Desktop Digital Equipment DEC 3000 300 AXP Series. Digital Equipment DEC 3000 300 AXP Series 13 halaman.

Halaman Cetak
7. Connect the Network Hardware
Note: If you are not connecting your system to a
network, go to panel 8.
See your system manager or network administrator to:
1. Determine whether network registration is required.
2. Obtain a unique node name and address.
3. Configure the network software.
Next, determine which of the following network con-
nections you have:
• 10BASE-T (UTP or twisted-pair)
• 10BASE2 (ThinWire)
• AUI
Connecting Your Workstation to 10BASE-T:
For a 10BASE-T (UTP) network you can connect
directly to your office 10BASE-T Ethernet using the
10BASE-T network cable provided with your system.
Connect this network cable from the 10BASE-T
connector on the back of the system unit to your
10BASE-T office network connection.
Connecting Your Workstation to 10BASE2:
For a 10BASE2 (ThinWire) network, you need to
purchase the optional DETTR-AA/AB adapter from
Digital and then:
• Connect your 10BASE-T network cable from the
10BASE-T connector on the back of the system
unit to the 10BASE-T connector
adapter.
• Connect your 10BASE2 office network cable
Port 1 on the adapter using a T-connector, as shown
in the next figure. If this is the end of the ThinWire
segment, attach a terminator to the T-connector,
opposite the network cable.
1
at Port 2 on the
3
to
2
4
PORT 1
PORT 2
MDI
MDI X
Off
On
10 BASE-T
ThinWire
1
3
• Set the internal termination switch on the adapter
to the off position.
4
• Set the switch at Port 2
• Connect the power cord
wall outlet.
Connecting Your Workstation to an AUI Drop:
For connection to an AUI drop, you need to purchase
the optional DETTR-BA/BB adapter from Digital and
then:
• Connect your 10BASE-T network cable from the
10BASE-T connector on the back of the system
unit to the 10-BASE-T connector
adapter.
• Connect your office AUI drop
adapter, as shown in the next figure.
• Check with your system manager to ensure that the
SQE/Heartbeat function is disabled on any device
that is connected to the AUI side of the adapter.
The DETTR-BA/BB will not function correctly in
the presence of a Heartbeat.
(continued on next panel)
POWER
6
MLO-010692
to the MDI X position.
2
from the adapter to a
6
at Port 2 on the
1
to Port 1 on the
5