Bittium OmegaSnap 1-CH ECG Electrode Panduan Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Cepat untuk Peralatan Medis Bittium OmegaSnap 1-CH ECG Electrode. Bittium OmegaSnap 1-CH ECG Electrode 2 halaman.

Halaman Cetak

Quick Guide - Bittium OmegaSnap™ 1-CH ECG Electrode

If needed, remove excess body

hair using a razor or an electric

shaver. Clean the skin according

to the instructions given by your

clinic or the person responsible

for treatment. The skin should be

clean and dry when attaching the

electrode.

Make sure the electrode pouch is unopened and check the date

before use. Tear open the pouch and remove the electrode.

Remove the plastic liner (marked

as number 1) of the electrode. Do

not touch the adhesive surface

with fingers.

Fix the electrode onto the skin.

Place the top of the electrode

approximately two fingers' width

below the suprasternal notch.

Optimal signal quality is obtained

when the electrode is fully placed

on top of the thorax and the

bottom of the electrode is above

the diaphragm.

When the electrode is properly

attached, remove the liners from

the sides (marked as number 2).

One at a time, remove to the side

while making sure the electrode

attaches to the skin.

Make sure the surface of the

Faros device and OmegaSnap

adapter are undamaged*.

Connect device to the adapter. To

ensure a good connection, pinch

device and the adapter together

with thumb and index finger.

Attach adapter to the electrode.

Press the device against the

electrode to make sure the snap

fasteners are connected.

Press and release the power

button to start measuring. A

sound and blinking green light

indicate that measurement has

started.

*If you notice any visual damage (e.g. a crack or dent), please contact your clinic for

further instructions.

Quick Guide - Bittium OmegaSnap™ 1-CH ECG Electrode

When you want to end the

measurement, press and hold

the power button for approx.

8 seconds. The device beeps

three times and the blinking

light turns off.

Remove the electrode off the skin by peeling back an edge

of the patch and then gently pulling off the rest of the patch.

You can use mild soapy water if necessary. Dispose of the

used electrode in accordance with local waste management

practices. Return the Faros ECG device and the OmegaSnap

adapter to your clinic or person responsible for treatment.

Symbols

CE mark

Manufacturing date

Manufacturer

Follow instructions for use

Medical Device

**USA users please note:

For prescriptions use, use only by designated healthcare professionals

8 sec.

Do not reuse

Lot number

Use-by date

Prescription use only**