Siemens SIMATIC ET 200AL Manual - Halaman 36

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Industri Siemens SIMATIC ET 200AL. Siemens SIMATIC ET 200AL 38 halaman. 10-link digital output module dq 8x24vdc/2a 8xm12
Juga untuk Siemens SIMATIC ET 200AL: Manual (50 halaman), Manual (38 halaman), Manual (32 halaman), Manual (37 halaman), Panduan Peralatan (46 halaman), Manual (26 halaman), Panduan Peralatan (28 halaman), Panduan Peralatan (27 halaman), Manual (25 halaman)

Halaman Cetak
Siemens SIMATIC ET 200AL Manual
PROFIenergy

8.4 IO-Link operating mode

8.4
IO-Link operating mode
Display
Switching off the supply voltage 1U
Response to error detection
All channels which are set to "PE_MODE_PROCEED" and "PE_MODE_LAST_VALUE" in
pause mode report errors as in productive operation.
The following conditions apply to all channels (ports) which switch to a different pause mode
("PE_MODE_SHUTDOWN" and "PE_MODE_SUBST_VALUE"):
● Switching off the supply voltage U
generation of the alarms "Wire break" and "Short circuit".
● Error detection is not possible during the "pause" (no IO-Link device communication):
– Alarms for errors already pending before the "pause" are retained.
– After the "pause" is over, the error status is updated and incoming/outgoing errors are
Mode parameter
The following table shows the "Mode" parameter.
Table 8- 3
Element
Mode
Supply voltage 1U
1
supplied with voltage.
36
reported correspondingly.
Mode parameter
Code
0
: PE_MODE_PROCEED
D
1
: PE_MODE_SHUTDOWN
D
3
: PE_MODE_LAST_VALUE
D
4
: PE_MODE_SUBST_VALUE
D
of the assigned port is switched off. Result: The IO-Link device is no longer
S
also switches off the associated port status LED Cn.
S
(port) upon starting the "pause" does not lead to
Sn
Explanation
Proceed at "pause"
Value status "GOOD"
•
Switch off at "pause"
Supply voltages 1U
•
Pause substitute value (input): 0
•
Value status "BAD"
•
Last value at "pause"
Pause substitute value: Last input value
•
Value status "BAD"
•
Substitute value at "pause"
Supply voltages 1U
•
Pause substitute value (input): 0
•
Value status "BAD"
•
Communication module CM 4xIO-Link 4xM12(6ES7147-5JD00-0BA0)
and 2U
off
1
S
A
B
and 2U
off
1
S
A
B
Manual, 10/2017, A5E32352322-AE