Siemens SIMATIC ET 200SP Manual - Halaman 16

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Industri Siemens SIMATIC ET 200SP. Siemens SIMATIC ET 200SP 37 halaman. Distributed i/o system
Juga untuk Siemens SIMATIC ET 200SP: Manual (40 halaman), Panduan Pengguna (21 halaman), Manual (34 halaman), Manual (48 halaman), Manual (30 halaman), Manual (34 halaman), Informasi Produk (38 halaman), Manual (36 halaman), Manual (44 halaman), Manual (31 halaman), Manual (35 halaman), Manual (23 halaman), Panduan Konfigurasi (20 halaman), Manual (34 halaman), Manual (29 halaman), Manual (33 halaman), Manual (31 halaman), Panduan Pengguna (32 halaman), Manual (31 halaman), Manual (28 halaman), Manual (41 halaman), Manual (32 halaman), Manual (49 halaman), Manual (24 halaman), Manual (34 halaman), Manual (41 halaman), Manual (30 halaman), Manual (31 halaman), Manual (27 halaman), Manual (24 halaman), Manual (24 halaman), Manual (25 halaman), Manual (49 halaman), Manual (40 halaman), Manual (38 halaman), Manual (39 halaman), Informasi Produk (24 halaman), Manual (32 halaman), Informasi Produk (10 halaman), Panduan Peralatan (43 halaman), Manual (33 halaman), Panduan Peralatan (44 halaman), Petunjuk Pengoperasian Asli (6 halaman), Manual (35 halaman), Manual (28 halaman), Panduan Peralatan (32 halaman), Manual (50 halaman), Manual (30 halaman), Manual (26 halaman), Manual (28 halaman), Manual (34 halaman), Manual (44 halaman), Manual (33 halaman), Panduan Peralatan (42 halaman), Manual Petunjuk Asli (16 halaman)

Sensor type

Specifies which sensor type is connected (see Table 3-1 Pin assignment for

DI 8×NAMUR HF (Page 9)).

For the following sensor types

● NAMUR changeover contact

● Changeover contact, unconnected

● Changeover contact with 10 kΩ

the following applies: The normally open contact channel must be set according to the

sensor type. The normally closed contact channel must be deactivated.

If "Channel deactivated" is shown, this means that the channel is not activated.

Pulse stretching

Sets whether and for how long pulse stretching is to take place.

Pulse stretching is a function for changing a digital input signal. A pulse at a digital input is

extended to at least the configured length. If the input pulse is already longer than the

configured length, then the pulse will not be changed.

Inverted

Specifies whether or not the input signal is to be inverted.

Inversion is only possible with the following sensor types:

● NAMUR sensor

● Single contact, unconnected

● Single contact with 10 kΩ

Potential group

Specifies that a BaseUnit with an incoming supply voltage is located in this slot (see

ET 200SP distributed I/O system

(http://support.automation.siemens.com/WW/view/en/58649293) system manual).