Siemens SIMATIC ET 200SP Manual - Halaman 20

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Industri Siemens SIMATIC ET 200SP. Siemens SIMATIC ET 200SP 30 halaman. Distributed i/o system
Juga untuk Siemens SIMATIC ET 200SP: Manual (40 halaman), Panduan Pengguna (21 halaman), Manual (34 halaman), Manual (48 halaman), Manual (30 halaman), Manual (34 halaman), Informasi Produk (38 halaman), Manual (37 halaman), Manual (36 halaman), Manual (44 halaman), Manual (31 halaman), Manual (35 halaman), Manual (23 halaman), Panduan Konfigurasi (20 halaman), Manual (34 halaman), Manual (29 halaman), Manual (33 halaman), Manual (31 halaman), Panduan Pengguna (32 halaman), Manual (31 halaman), Manual (28 halaman), Manual (41 halaman), Manual (32 halaman), Manual (49 halaman), Manual (24 halaman), Manual (34 halaman), Manual (41 halaman), Manual (31 halaman), Manual (27 halaman), Manual (24 halaman), Manual (24 halaman), Manual (25 halaman), Manual (49 halaman), Manual (40 halaman), Manual (38 halaman), Manual (39 halaman), Informasi Produk (24 halaman), Manual (32 halaman), Informasi Produk (10 halaman), Panduan Peralatan (43 halaman), Manual (33 halaman), Panduan Peralatan (44 halaman), Petunjuk Pengoperasian Asli (6 halaman), Manual (35 halaman), Manual (28 halaman), Panduan Peralatan (32 halaman), Manual (50 halaman), Manual (30 halaman), Manual (26 halaman), Manual (28 halaman), Manual (34 halaman), Manual (44 halaman), Manual (33 halaman), Panduan Peralatan (42 halaman), Manual Petunjuk Asli (16 halaman)

Halaman Cetak
Siemens SIMATIC ET 200SP Manual
Parameters/address space

4.3 Address space

4.3
Address space
Address space of the communication module
The input addresses of the communications module total 8 bytes. The input addresses are
automatically assigned for each communications module when you specify the device
configuration in STEP 7 (TIA Portal). Output addresses are not required.
Hardware identification (not freely configurable)
The hardware identification (HW ID) is automatically assigned for each communications
module when you specify the device configuration in STEP 7 (TIA Portal).
The hardware ID is issued along with the diagnostic messages to localize the module. In
addition, the HW identification is required for S7-1500 at the communication instructions in
order to identify the communication module. For S7-300/400, the communication module is
identified by the start address of the input data.
20
CM PtP communication module (6ES7137-6AA00-0BA0)
Manual, 01/2013, A5E03790792-01