Siemens SIMATIC ET 200SP HA Panduan Peralatan - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Peralatan untuk Peralatan Industri Siemens SIMATIC ET 200SP HA. Siemens SIMATIC ET 200SP HA 38 halaman. Distributed i/o devices busadapter for distributed i/o
Juga untuk Siemens SIMATIC ET 200SP HA: Manual (32 halaman), Manual (50 halaman), Manual (34 halaman), Manual (38 halaman), Panduan Peralatan (44 halaman), Panduan Peralatan (50 halaman), Panduan Peralatan (46 halaman), Panduan Peralatan (42 halaman), Panduan Peralatan (44 halaman), Panduan Peralatan (36 halaman), Panduan Peralatan (38 halaman)

Halaman Cetak
Siemens SIMATIC ET 200SP HA Panduan Peralatan
Parameters

5.3 Explanation of the module/channel parameters

Parameters
Potential group (Page 19)
Double-width terminal block
(Page 20)
2
The wire break diagnostics can only be enabled when the "Check for wire break" parameter is enabled. If you use a simple
1
encoder contact, you need to connect a parallel resistor to enable wire break diagnostics in the open state (sensor resistance
for wire break diagnostics: 15 kΩ to 18 kΩ).
I/O module on terminal block with potential distributor: Select the "Double-width terminal block" parameter in the hardware
2
properties for the I/O module.
5.3
Explanation of the module/channel parameters
5.3.1

Diagnostics, Missing supply voltage L+

Definition
Enabling of the diagnostics for missing or insufficient supply voltage L+.
5.3.2

Diagnostics, Wire break

Definition
When wire-break check is activated, you can enable wire-break diagnostics via the Diagnostics,
Wire break parameter for insufficient current flow on the input.
5.3.3

Wire-break check

Definition
Enable for wire break check. The I/O module can only detect a wire break if wire-break is
activated.
18
Value range
•
Potential group of the left mod‐
ule (dark gray terminal block)
•
New potential group (light gray
terminal block)
•
No potential group (black termi‐
nal block)
•
Enabled
•
Disabled
Default
Parameter re‐
assignment in
RUN
Use potential
No
group of the left
module
Disabled
No
Equipment Manual, 10/2021, A5E48262828-AB
Efficiency range
Module
Configuration (HW
Config)
DI 32x24VDC HA