Siemens SIMATIC NET Panduan Instalasi - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Peralatan Industri Siemens SIMATIC NET. Siemens SIMATIC NET 34 halaman. Network components bus terminal
Juga untuk Siemens SIMATIC NET: Panduan Petunjuk Pengoperasian (29 halaman), Panduan Petunjuk Pengoperasian (50 halaman), Panduan Petunjuk Pengoperasian (28 halaman), Manual Petunjuk Perakitan (6 halaman), Informasi Produk (6 halaman), Panduan Instalasi (40 halaman), Panduan Instalasi (50 halaman), Panduan Instalasi (40 halaman), Panduan Referensi (14 halaman), Panduan Instalasi (48 halaman), Panduan Petunjuk Pengoperasian (32 halaman)

Installing the Device

2.4 Installing the Device Outdoors

Removing the Device

To remove the device from a DIN rail, do the following:

2.4

Installing the Device Outdoors

When installing the RP100 outdoors, make sure there is a solid connection between

the lightning protector and the CPE/PD. The following illustration details a typical

installation:

Note

A shielded cable must be used and connected to local ground at both the RP100 and

CPE/PD.

Note

The lightning protector must meet the necessary requirements of IEC/UL/CSA

62368-1. The clamping voltage must also be less than 60 V and the protector must

not activate when the voltage is less than 56 V. For more information, contact

Siemens Customer Support.

Insert a flathead screwdriver into the slot of the sliding release and move it

down.

DIN Rail

DIN Rail Adapter

Figure 2.2

Removing the Device from a DIN Rail

Swing the bottom of the device away from the DIN rail.

Lift the device off the DIN rail.

Installation Manual, 01/2021, C79000-G8976-1011-05

RUGGEDCOM RP100