Siemens Simatic S7-1500 Panduan Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Industri Siemens Simatic S7-1500. Siemens Simatic S7-1500 44 halaman. Digital output module dq 16x230vac/2a st relais (6es7522-5hh00-0ab0)
Juga untuk Siemens Simatic S7-1500: Manual (40 halaman), Manual (37 halaman), Manual (47 halaman), Manual (24 halaman), Manual (34 halaman), Panduan Pengguna (45 halaman), Manual (27 halaman), Panduan Konfigurasi (20 halaman), Manual (47 halaman), Manual (43 halaman), Manual (48 halaman), Manual (26 halaman), Manual (28 halaman), Manual (50 halaman), Manual (34 halaman), Manual (50 halaman), Manual (30 halaman), Manual (41 halaman), Manual (50 halaman), Manual (40 halaman), Manual Pemrograman Keselamatan (48 halaman), Panduan Instruksi Komunikasi (36 halaman), Manual (40 halaman), Manual (25 halaman), Manual (42 halaman), Deskripsi Aplikasi (50 halaman), Manual (28 halaman), Manual (33 halaman), Manual (49 halaman), Manual (36 halaman), Manual (41 halaman), Manual (46 halaman), Manual (38 halaman), Manual (35 halaman), Manual (39 halaman), Manual (28 halaman), Manual (35 halaman), Panduan Peralatan (35 halaman), Manual (50 halaman), Panduan Peralatan (32 halaman), Panduan Peralatan (38 halaman), Manual (29 halaman), Panduan Peralatan (38 halaman), Manual (34 halaman), Manual (36 halaman), Panduan Peralatan (50 halaman), Manual (45 halaman)

Wiring

Note

When the 24 V supply voltage is switched on at each channel, there is a "1" signal at the

module outputs for approx. 50 μs.

Tip: Using the potential jumpers

If you want to supply both load groups with the same potential (non-isolated), use the

potential jumpers supplied with the front connector. This helps you to avoid having to

terminate two wires to one terminal.

Proceed as follows:

1. Connect the 24 V DC supply voltage to terminals 19 and 20.

2. Insert the potential jumpers between terminals

– 9 and 29 (L+)

– 10 and 30 (M)

– 19 and 39 (L+)

– 20 and 40 (M)

3. Insert the jumpers between terminals 29 and 39, as well as 30 and 40.

4. Use the terminals 19 and 20 to distribute the potential to the next module.

Figure 3-2

Note

Ensure that the maximum current load of 8 A per potential jumper is not exceeded.

Using the potential jumpers

Digital output module DQ 16x24VDC/0.5A HF (6ES7522-1BH01-0AB0)

Manual, 06/2018, A5E35683409-AC