Siemens Simatic S7-1500 Panduan Peralatan - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Peralatan untuk Peralatan Industri Siemens Simatic S7-1500. Siemens Simatic S7-1500 35 halaman. Digital output module dq 16x230vac/2a st relais (6es7522-5hh00-0ab0)
Juga untuk Siemens Simatic S7-1500: Manual (40 halaman), Manual (37 halaman), Manual (47 halaman), Manual (24 halaman), Manual (34 halaman), Panduan Pengguna (45 halaman), Manual (27 halaman), Panduan Konfigurasi (20 halaman), Manual (47 halaman), Manual (43 halaman), Manual (48 halaman), Manual (26 halaman), Manual (28 halaman), Manual (50 halaman), Manual (34 halaman), Panduan Pengguna (44 halaman), Manual (50 halaman), Manual (30 halaman), Manual (41 halaman), Manual (50 halaman), Manual (40 halaman), Manual Pemrograman Keselamatan (48 halaman), Panduan Instruksi Komunikasi (36 halaman), Manual (40 halaman), Manual (25 halaman), Manual (42 halaman), Deskripsi Aplikasi (50 halaman), Manual (28 halaman), Manual (33 halaman), Manual (49 halaman), Manual (36 halaman), Manual (41 halaman), Manual (46 halaman), Manual (38 halaman), Manual (35 halaman), Manual (39 halaman), Manual (28 halaman), Manual (35 halaman), Manual (50 halaman), Panduan Peralatan (32 halaman), Panduan Peralatan (38 halaman), Manual (29 halaman), Panduan Peralatan (38 halaman), Manual (34 halaman), Manual (36 halaman), Panduan Peralatan (50 halaman), Manual (45 halaman)

Siemens Simatic S7-1500 Panduan Peralatan
Meaning of the LED displays
The following table explains the meaning of the status and error displays.
RUN and ERROR LED
Table 5- 1
RUN and ERROR status and error displays
LED
RUN
ERROR
Off
Off
Off
Flashes
On
Off
Flashes
Flashes
CHx LED
Table 5- 2
CHx status display
LED CHx
Off
On
Digital output module DQ 16x230VAC/1A ST Triac (6ES7522-5FH00-0AB0)
Equipment Manual, 12/2021, A5E34934069-AC
Meaning
Voltage missing or too low at backplane bus
The module starts and flashes until the valid
parameter assignment is set.
Module parameters assigned
Hardware defective
Meaning
0 = Status of the output signal
1 = Status of the output signal
5.1 Status and error displays
Solution
Switch on the CPU and/or the system power
supply modules.
Verify that the U connectors are inserted.
Check whether too many modules are in-
serted.
---
Replace the module.
Solution
---
---
Diagnostic alarms
21