Siemens SIMATIC S7-200 Manual - Halaman 18

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Industri Siemens SIMATIC S7-200. Siemens SIMATIC S7-200 49 halaman. Ethernet gateway for simatic mpi/ profibus driver
Juga untuk Siemens SIMATIC S7-200: Manual (30 halaman), Manual (35 halaman), Panduan Pengemudi (28 halaman), Manual (18 halaman), Manual Sistem (20 halaman)

Halaman Cetak

Basic settings

3.2 Configuring the S7-200 communication

3.2

Configuring the S7-200 communication

1. Click the communications icon in the navigation bar.

2. Review the communications settings.

3. Double-click the corresponding field to refresh. The connected CPU should now be

recognized and registered automatically.

4. If the CPU is not recognized, or if a pop-up window tells you that communication is not

possible, double-click the field PC/PPI cable.

5. Select PC/PPI cable in the Set PG/PC Interface dialog and select Properties.

6. In the PPI tab, set the station address to 0 and set the transmission rate to 9.6 kbps. In

the Local Connection tab, select the USB port. Click OK to confirm all settings and close

the Properties dialog. Click OK to close the Set PG/PC Interface dialog. Note that the

station address cannot be the same number as the CPU address.

7. Double-click the corresponding field in the communications field to refresh. The CPU will

now be recognized and registered automatically. The process could take a few seconds.

Now click OK to close the Communications dialog.

Getting Started - Beginners

Training Documents, 07/2007, A5E01031470B