Siemens SIREMOBIL Iso-C Manual Petunjuk Servis - Halaman 3

Jelajahi secara online atau unduh pdf Manual Petunjuk Servis untuk Peralatan Industri Siemens SIREMOBIL Iso-C. Siemens SIREMOBIL Iso-C 16 halaman.
Juga untuk Siemens SIREMOBIL Iso-C: Petunjuk Instalasi dan Pengaturan (4 halaman), Manual Petunjuk Instalasi dan Pengaturan (6 halaman), Instruksi Pemeliharaan (46 halaman), Panduan Petunjuk Instalasi (6 halaman)

Replacing the horizontal lift brake

Preliminary steps

CAUTION

Fig. 1

•

Connect the SIREMOBIL Iso-C to power .

•

Position the wooden block (1/Fig. 1) underneath.

•

Move the C-arm into the horizontal position (Fig. 1).

•

Position the C-arm over the work table.

•

Slowly move the lifting column down in increments until the C-arm is positioned just flat

on the table. When doing this, make sure that the work table is centered around the C-

arm and that as much of the railing as possible is lying on the table.

NOTICE

Disassembly

•

Switch OFF the SIREMOBIL Iso-C.

•

Remove the docking plate for the MODULARIS, if it is connected.

•

Remove the cover with the brake switches (2/Fig.1) (screws are on the underside).

When doing this, remove the ground cable and disconnect the connection to the switch

board.

Siemens AG

Medical Engineering

Push the wooden block under the SIREMOBIL frame prior to removing

the C-arm for service. Otherwise, the frame may tip over when the C-arm

is removed from the lifting column.

When placing the C-arm on the table, lower the lifting column only far

enough until the C-arm is positioned flat on the table with the entire rail-

ing.

Fig. 1 shows one possible arrangement using 2 smaller work tables.

SPR2-230.076.01

Rev. 01

Page 3 of 16

02/99

TD SD 24

SIREMOBIL Iso-C