Siemens SITRANS F M Verificator Panduan Petunjuk Pengoperasian - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Industri Siemens SITRANS F M Verificator. Siemens SITRANS F M Verificator 38 halaman.
Halaman Cetak
3.5
Verificator software - installation passed
Verification is finished and data stored in the selected file. If a new verification is required, press
GO to revert to "select file".
A new file for the next verification can be selected. Otherwise, the verificator may now be safely
switched off and disconnected.
Verification finished
Transmitter:
Sensor:
Press GO to continue
3.6
Verificator software - part test
To select a part test, select either insulation or magnetism test.
The test result will not be stored and you will not be able to get a print out.
Select file name:
File #19
File #20
>Part test only <
For the insulation test use the "up" or "down" arrow to select insulation test only.
Select test
->Insulation only<-
Press GO to start
Press ESC to cancel
When finish you will get the information if a test passed or failed.
Sensor passed
Insulation OK
Press GO to continue
For magnetism test use the "up" or "down" arrows to select magnetism test only.
Select test
->magnetism test only<-
Press GO to start
Press ESC to cancel
SITRANS F M Verificator
Operating Instructions, 07/2019, A5E45134218-AB
Passed
Passed
Operating (hardware)
3.6 Verificator software - part test
15