Siemens SITRANS WW310 Panduan Petunjuk Pengoperasian - Halaman 25
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Industri Siemens SITRANS WW310. Siemens SITRANS WW310 48 halaman. Weighfeeders
Halaman Cetak
Start Up
Your weighfeeder has been factory run-in for a minimum of four hours; it should require little
adjustment. However, periodic inspections of the belt tracking are recommended.
Start the belt and observe rotation.
Turn off and lock out all power sources before correcting rotation. On AC motors, reverse 2
of the 3 motor wires.
Start the belt again, and observe the machine as it is running. If the belt is not tracking correctly,
or is travelling off center, see Belt tracking (Page 26).
8.1
Shear gate
The shear gate on the inlet of the weighfeeder needs to be set to allow the maximum feedrate
capacity required. Consult your Siemens representative if feed rate changes are required.
8.2
Skirtboards
The skirtboards have been factory set to proper specifications. Note that near the inlet, the
skirtboards are very close to the belt. However, toward the discharge end of the weighfeeder,
the skirtboards are 3 to 5 mm (1/8 to 3/16") higher off the belt. This relieving effect minimizes the
possibility of material becoming lodged between the skirtboard and the belt.
Periodic adjustments of the skirtboards should not be necessary but if adjustment is required,
set the skirtboards at the heights described above.
SITRANS WW310
Operating Instructions, 03/2014, A5E33490433-AA
WARNING
8
23