Cisco WS-X5161 Manual - Halaman 30

Jelajahi secara online atau unduh pdf Manual untuk Beralih Cisco WS-X5161. Cisco WS-X5161 33 halaman. Configuring token ring lan emulation
Juga untuk Cisco WS-X5161: Buletin Dukungan Produk (6 halaman)

Halaman Cetak

Token Ring LANE Configuration Example

Configuring the LES BUS and the LEC Example

To configure the LES/BUS and LEC, perform the following tasks:

SUMMARY STEPS

1. Set up the prefix of the ATM NSAP address for the switch.

2. Start a session to the ATM module by entering the session 4 interface configuration command. You see

the following display:

3. Obtain the addresses of the LES/BUS for later use by entering the enable router configuration

command (to enable configuration mode) and the show lane default-atm-addresses EXEC command at

the ATM prompt. You see the following display:

4. Using the LECS address obtained in Step 3, set the address of the default LECS in the LightStream

1010 switch by entering the configure terminal and atm lecs-address-default commands on the console

of the LightStream 1010 switch. You see the following display:

5. Save the configuration to NVRAM by entering the write memory command, as follows:

6. Start a LES/BUS pair on Catalyst 5000 series switch 1 by entering the interface atm0 and the lane

server-bus tokenring commands in global configuration mode. On the console of Catalyst 5000 series

switch 1, enter the following commands:

7. Save the configuration in NVRAM entering the write memory command, as follows:

8. Set up the LECS database on the Catalyst 5000 series switch 1.

9. Save the configuration in NVRAM by entering the write memory command, as follows:

10. Start and bind the LECS on the Catalyst 5000 series switch 1 by entering the interface atm0, the lane

config database database_name interface configuration command, and the lane config auto-config-atm-

address interface configuration commands at the ATM prompt. You see the following display:

11. Save the configuration in NVRAM by entering the write memory command, as follows:

12. Start the LEC on the Catalyst 5000 series switches 1 and 2 by entering the interface atm0.1 command

and the lane client tokenring 112 crf112 interface configuration command in configuration mode on the

consoles of switches 1 and 2. The interface on which the LEC is configured is atm0.1. The ELAN name

is default, and it is configured to emulate Token Ring. You see the following display:

13. Save the configuration in NVRAM by entering the write memory command, as follows:

DETAILED STEPS

Step 1

Set up the prefix of the ATM NSAP address for the switch.

The LightStream 1010 ATM switch provides a default prefix.

Step 2

Start a session to the ATM module by entering the session 4 interface configuration command. You see the following

display:

Example:

Console> session 4

Trying ATM-4...

Connected to ATM-4.

Configuring the LES BUS and the LEC Example