Cisco WS-X5168 Manual - Halaman 11

Jelajahi secara online atau unduh pdf Manual untuk Beralih Cisco WS-X5168. Cisco WS-X5168 33 halaman. Configuring token ring lan emulation
Juga untuk Cisco WS-X5168: Buletin Dukungan Produk (6 halaman)

Halaman Cetak
Cisco WS-X5168 Manual

Displaying LANE Default Addresses

Command or Action
Step 2 ATM(config)# atm pvcvcd vpi vci
qsaal
Step 3 ATM(config)# atm pvcvcd vpi
vciilmi
Displaying LANE Default Addresses
You can display the LANE default addresses to make configuration easier. Complete this task for each
Catalyst 5000 series switch ATM interface that participates in LANE. The show lane default-atm-
addressEXEC command displays default addresses for all ATM interfaces present on the switch. Write
down the displayed addresses on your LANE worksheet.
To display the default LANE addresses, use the following command in global configuration mode:
Command
ATM#
interface atm
[
.
[
subinterface-number
]]

Entering the LECS ATM Address on the LightStream 1010 Switch

You must enter the LECS ATM address into each ATM switch (such as a Cisco LightStream 1010 ATM
switch) connected to an ATM module in your LANE network and save the address permanently so that the
value will not be lost when the switch is reset or powered off. Programming the LECS addresses allows the
LESs and LECs to determine the LECS addresses dynamically through ILMI.
To enter a LECS ATM address into a LightStream 1010 switch and save it there permanently, use the
following commands on the Cisco LightStream 1010 switch beginning in global configuration mode:
SUMMARY STEPS
1. Switch(config)# atm lecs-address-default address1 [address2... ]
2. Router(config)# exit
3. Switch# copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 Switch(config)# atm lecs-address-default
address1 [address2... ]
Step 2 Router(config)# exit
Purpose
Establishes the signalling PVC that sets up and tears down switched virtual circuits
(SVCs); the vpi and vci values are usually set to 0 and 5, respectively. The vcd is the
virtual channel descriptor.
Sets up a PVC to communicate with the ILMI; the vpi and vci values are usually set
to 0 and 16, respectively.
show lane default-atm-addresses
number
Specifies the LECS's ATM address for the entire switch. Use the
addresses from your LANE worksheet and specify the full 40-digit
ATM address.
Exits global configuration mode.
Purpose
Displays the LANE default addresses.
Purpose
Default LANE Configuration
11