Epson 1715C - PowerLite XGA LCD Projector Buku Panduan Instalasi

Jelajahi secara online atau unduh pdf Buku Panduan Instalasi untuk Proyektor Epson 1715C - PowerLite XGA LCD Projector. Epson 1715C - PowerLite XGA LCD Projector 8 halaman. Remote control information
Juga untuk Epson 1715C - PowerLite XGA LCD Projector: Panduan Pengguna (42 halaman), Panduan Pengoperasian (36 halaman), Pengaturan Cepat (4 halaman), Panduan Pengoperasian (47 halaman), Panduan Instalasi (19 halaman), Panduan Pengguna (1 halaman), Daftar Bagian (1 halaman), Pembaruan Dokumentasi (12 halaman), Manual Fungsi (5 halaman), Manual Perangkat Lunak (2 halaman), Buletin Dukungan Produk (25 halaman), Buletin Dukungan Produk (22 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (41 halaman), Buletin Dukungan Produk (34 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (15 halaman), Buletin Dukungan Produk (22 halaman), Spesifikasi (2 halaman)

Halaman Cetak

Epson 1715C - PowerLite XGA LCD Projector Buku Panduan Instalasi

Epson PowerLite 1715c

note

If a button is pressed longer

than 30 seconds, the remote

control stops operating to

conserve power. When you

release the button, normal

operation resumes.

caution

When replacing batteries,

take the following

precautions:

Replace the batteries as

soon as they run out. If the

batteries leak, wipe away

battery fluid with a soft

cloth. If fluid gets on your

hands, wash immediately.

Do not expose batteries to

heat or flame.

Dispose of used batteries

according to local

regulations.

Remove the batteries if

you won't be using the

projector for a long period of

time.

Using the Remote Control

Follow these tips for using the remote control:

Point the remote control at the front of the projector or at the

screen.

Stand within 20 feet of the projector.

Avoid using the remote under bright fluorescent lamps or in

direct sunlight, or the projector may not respond properly.

Replacing the Batteries

Replace the batteries as described below:

1. Turn the remote control over.

2. Press down on the tab on the

battery cover as you lift the cover

off.

3. Install two AAA batteries,

inserting the

and

ends as

–

shown.

4. Position the cover as shown, then

press down until it snaps into

place.

INSTALLATION HANDBOOK

Remote Control Information