Samsung 3 SERIES Panduan Pengguna - Halaman 43

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Monitor Samsung 3 SERIES. Samsung 3 SERIES 47 halaman. Led tv monitor
Juga untuk Samsung 3 SERIES: Panduan Pengguna (43 halaman), Panduan Pengguna (33 halaman), Panduan Pengaturan Cepat (4 halaman), Panduan Pengguna (20 halaman), Panduan Pengguna (20 halaman), Panduan Pengguna (46 halaman)

Other Information

Issues

The PIP menu is not available.

You turned the LED display off 45 minutes

ago, and it turned on again.

The message "Scramble signal" or "Weak

Signal/No Signal" appears.

There are recurrent picture/sound issues.

A reaction may occur between the rubber

cushion pads on the base stand and the

top finish of some furniture.

✎

This panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However, there may be a

few bright or dark pixels on the screen. These pixels will have no impact on the performance of the product.

Storage and Maintenance

✎

If you attched some stickers on the LED display screen, it remains some debris after removing the sticker. Please clean it to

watch LED display.

✎

The exterior and screen of the product can get scratched during cleaning. Be sure to wipe the exterior and screen carefully

using the cloth provided or a soft cloth to prevent scratches.

Do not spray water or a cleaning agent directly onto the product.

Any liquid that goes into the product may cause a failure, fire, or

electric shock.

[

CAUTION

If the height of "

" on one side is different from the other side,

adjust the heights.

Solutions and Explanations

• PIP functionality is only available when you are using a HDMI source.

• It is normal. The LED display operates the OTA (Over The Aerial) function itself to upgrade firmware

downloaded whilst your watching LED display.

• If you are using a CAM CARD (CI/CI+), check that it is installed into the common interface slot.

• If there is still a problem, pull the CAM CARD out of the LED display and insert it into the slot again.

• Check and change the signal/source.

• To prevent this, use felt pads on any surface of the LED display that comes in direct contact with

furniture.

Clean the product with a soft cloth dapped in a small amount of

water.

English