Cisco 3600 Series Panduan Konfigurasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Telepon IP Cisco 3600 Series. Cisco 3600 Series 36 halaman. Memory upgrade
Juga untuk Cisco 3600 Series: Ikhtisar Produk (10 halaman), Petunjuk Peningkatan (30 halaman), Panduan Pemilik (17 halaman), Catatan Aplikasi (41 halaman), Panduan Pengguna (25 halaman), Lampiran (15 halaman), Panduan Pengguna (7 halaman), Manual (5 halaman), Catatan Konfigurasi (23 halaman), Catatan Konfigurasi (18 halaman), Catatan Konfigurasi (25 halaman)

Halaman Cetak
Cisco 3600 Series Panduan Konfigurasi
You should configure RTP header compression if the following conditions exist in your network:
•
•
Note
Perform the following tasks to configure RTP header compression for Voice over IP. The first task is
required; the second task is optional.
•
•
Enable RTP Header Compression on a Serial Interface
To use RTP header compression, you need to enable compression on both ends of a serial
connection. To enable RTP header compression, use the following command in interface
configuration mode:
Command
ip rtp header-compression [passive]
If you include the passive keyword, the software compresses outgoing RTP packets only if incoming
RTP packets on the same interface are compressed. If you use the command without the passive
keyword, the software compresses all RTP traffic.
Change the Number of Header Compression Connections
By default, the software supports a total of 16 RTP header compression connections on an interface.
To specify a different number of RTP header compression connections, use the following command
in interface configuration mode:
Command
ip rtp compression connections number
RTP Header Compression Configuration Example
The following example enables RTP header compression for a serial interface:
For more information about RTP header compression, see the "Configuring IP Multicast Routing"
chapter of the Network Protocols Configuration Guide, Part 1.
Slow links
Need to save bandwidth
RTP header compression should not be used on links greater than 2 Mbps.
Enable RTP Header Compression on a Serial Interface
Change the Number of Header Compression Connections
interface 0
ip rtp header-compression
encapsulation ppp
ip rtp compression-connections 25
Configure RTP Header Compression
Purpose
Enable RTP header compression.
Purpose
Specify the total number of RTP header
compression connections supported on an interface.
Configuring Voice over IP for the Cisco 3600 Series VC-21