Cisco 522 Panduan Administrasi - Halaman 36

Jelajahi secara online atau unduh pdf Panduan Administrasi untuk Telepon IP Cisco 522. Cisco 522 48 halaman. Ip phones with multiplatform firmware
Juga untuk Cisco 522: Panduan Pengguna (46 halaman), Manual (40 halaman), Panduan Instalasi (39 halaman), Manual (24 halaman)

Halaman Cetak

Headset Management on Older Versions of Cisco Unified Communications Manager

For more information on the TFTP service, see the "Manage Device Firmware" chapter of the Administration

Guide for Cisco Unified Communications Manager and IM and Presence Service.

Upgrade your phones to the latest firmware release before you apply the defaultheadsetconfig.json

file. The following table describes the default settings you can adjust with the JSON file.

Table 10: Cisco Headset 500 Series Parameters and Default Settings

Parameter

Speaker Volume

Microphone Gain

Sidetone

Equalizer

Audio Bandwidth

Bluetooth

DECT Radio Range

Cisco Headset 500 Series Administration Guide

Headset Management on Cisco Unified Communications Manager Versions Older than 12.5(1)SU1

Range

Default

Notes

0 – 15

Controls the level of sound in the headset. 0 is very

low while 15 is loud. You can configure this setting

differently depending on the office environment in

which the headsets are deployed.

0 (Off) – 4

Controls how loud the user sounds to other people on

(High)

the call. 0 means users sound quiet while 4 means

users sound much louder. You can configure this

setting depending on how much ambient noise your

deployed headsets encounter.

0 (Off) – 3

Controls how much of a user's own voice they can

(High)

hear through their headset. 0 turns off sidetone while

3 means users receive much more feedback from their

headset microphones.

Controls the Equalizer, known on the phones as

(Warmest)

Tuning. A setting of 0 means that users hear more

– 6

bass in their headsets, while a setting of 6 means that

(Brightest)

users hear more treble.

0 (Wide

Controls DECT bandwidth. When you set the

Band), 1

bandwidth to narrow, Standard Base and Multibase

(Narrow

headsets are limited to the DECT codec G.726. Set

Band)

the audio bandwidth to Narrow Band if your wireless

headsets are used in a dense DECT environment.

0 (On), 1

Controls the use of Bluetooth on Cisco Headset 561

(Off)

and 562 with Multibase. The base forgets any devices

that have paired with it when this parameter is

changed.

You can disable Bluetooth if your users are operating

in an environment in which information security is at

a premium.

Controls DECT range. By default, the Standard Base

(autorange),

and Multibase have a DECT range of over 330 feet

1 (short

(100 meters) in ideal conditions. If you configure the

range), 2

DECT radio range to short, the headset base consumes

(medium

less power but users can't move as far from the base

range)

while on a call.