Cisco 6861 Panduan Penyebaran - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Penyebaran untuk Telepon IP Cisco 6861. Cisco 6861 33 halaman. Multiplatform phones wireless lan
Juga untuk Cisco 6861: Panduan Instalasi (39 halaman), Panduan Memulai Cepat (2 halaman)

Halaman Cetak

•

If PSK is selected to utilize Pre-Shared Key authentication, then a PSK Passphrase must be entered. The PSK

Passphrase must be 8-63 ASCII character string.

•

If WEP is selected to utilize static WEP (Wired Equivalent Privacy) authentication, then a WEP Key must be

entered.

•

Only WEP key 1 is supported. The entered key must match the transmit key on the access point side. The WEP

Key must be in one of the following formats:

▪ 40/64 Bit Key = 5 digits ASCII or 10 digits HEX character string

▪ 104/128 Bit Key = 13 digits ASCII or 26 digits HEX character string

•

If None is selected, then no authentication is required and no encryption will be utilized.

•

If Auto is selected, your phone dynamically chooses EAP-FAST, PEAP-MSCHAPv2, or PEAP-GTC as

authentication method based on communication with the target AP.

Frequency Band supports 5G, 2.4G, and Auto. Select the desired Frequency Band option:

•

Auto = Gives preference to 5 GHz channels, but operates on both 5 GHz and 2.4 GHz channels

•

2.4 GHz = Operates on 2.4 GHz channels only

•

5 GHz = Operates on 5 GHz channels only

Once the phone connects to the target AP, the connection info would be displayed on phone's web portal as the following

picture shows. Click the Info > Status to view the connection information.

Notes:

▪

Any change to the currently connected Wi-Fi profile would cause the phone to disconnect with the current

AP, warm reboot, then connect to current AP with the changed parameters.

▪

If you have a wired network deployed on your site, connect your phone to the wired network first. After

configuring Wi-Fi profiles on the phone web page, you can force the phone to connect to the configured

profile by disconnecting the wired network.

▪

All the Wi-Fi profiles are saved on the phone. The phone can recover the previous Wi-Fi connection after a

power cycle.

Wireless LAN Profiles (on Phone Screen)

To configure the Wi-Fi profiles on the phone screen, navigate to Network configuration > Wi-Fi configuration > Wi-Fi

profile.

Cisco IP Phone 6861 Multiplatform Phones Wireless LAN Deployment Guide