Cisco 7821 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon IP Cisco 7821. Cisco 7821 10 halaman. Connaught
Juga untuk Cisco 7821: Catatan Rilis (16 halaman), Panduan Memulai Cepat (2 halaman), Panduan Pengguna (18 halaman), Panduan Referensi Cepat (4 halaman), Referensi Cepat (4 halaman), Instalasi Cepat & Panduan Pengguna (12 halaman), Panduan Referensi (11 halaman), Panduan Memulai Cepat (4 halaman), Manual (27 halaman), Panduan Pengguna (20 halaman), Panduan Referensi Cepat Karyawan (4 halaman), Panduan Utama Migrasi Firmware (31 halaman), Manual (43 halaman), Panduan Memulai Cepat (6 halaman), Kartu Referensi Cepat (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Instalasi (39 halaman), Manual (20 halaman), Panduan Konfigurasi Ulang (2 halaman), Panduan Memulai Cepat (7 halaman), Panduan Instalasi Cepat (12 halaman), Panduan Pengguna (27 halaman), Panduan Pengguna (2 halaman), Memulai (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Pengguna (5 halaman)

Click on Voice at the top navigation menu.

Click on Provisioning sub menu.

You can use TFTP or HTTP protocols in order to Auto Provision your Cisco SPA device.

Choose which protocol you want to use:

- TFTP

- HTTP

TFTP

In the Profile Rule field enter tftp:// followed by Hostname or IP Address, followed then by

/$MA.cfg.

- Example for Hostname: tftp://voip.bicomsystems.com/$MA.cfg

- Example for IP Address: tftp://10.1.70.150/$MA.cfg

Click on Submit and wait 35 seconds. The phone may reboot.

Auto provisioning process will start during device reboot process, device will pickup

appropriate configuration file from PBXware. If everything is done as above described, you

should have successfully registered your device to PBXware.

HTTP

This chapter describes how to use HTTP protocol in order to register Cisco SPA device.

Your PBXware needs to be configured correctly for HTTP to work. Please make sure that HTTP

username and HTTP passwords are set in Auto provisioning section in Settings ->

Servers/Tenants -> Server/Tenant name [edit]. Contact your PBXware administrator. Bicom

Systems can provide service to set up this for you.

NOTE: