Cisco 7902G - Unified IP Phone VoIP Panduan Memulai Cepat - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Telepon IP Cisco 7902G - Unified IP Phone VoIP. Cisco 7902G - Unified IP Phone VoIP 29 halaman. Ip phone for cisco callmanager
Juga untuk Cisco 7902G - Unified IP Phone VoIP: Panduan Telepon (28 halaman)

Halaman Cetak

DC adapter port (DC48V)

Power supply with DC output connector. (Optional.

Required only if power is not supplied through an

Ethernet connection.)

Power cable with wall AC plug. Provided if your phone

uses external power.

Follow these steps to connect your Cisco IP Phone to the

corporate IP network.

Be sure to read the "Safety Notices" section on page 23

Step 1

before connecting your phone. Also, verify that your

system administrator is ready for you to connect your

phone to the network.

Use the Ethernet cable included with your phone to

Step 2

connect the network port on the back of your phone to

the Ethernet port in your workspace.

Connect the handset to the handset port. Ensure that

Step 3

the end of the cord with the longer uncoiled section is

connected to the body of the phone.

If your system administrator delivered your

Step 4

Cisco IP Phone with a power supply, connect the power

supply plug to the adapter port on the back of the

phone. Then use the power cable to connect the power

supply to a standard power outlet in your workspace.

If your system administrator delivered your phone

without a power supply, your phone probably receives

power through the Ethernet connection.

After you connect the Cisco IP Phone to its power source, a

start-up process begins. The phone uses a combination of the

three LEDs (handset, Hold and Menu buttons) to indicate the

phone start-up process. After several minutes, startup is

complete and your phone is ready to use. If you experience any

difficulties, refer to the "General Troubleshooting Tips" section

on page 17 or contact your system administrator.