Siemens IQ500 Petunjuk Instalasi dan Penggunaan Manual - Halaman 6
Jelajahi secara online atau unduh pdf Petunjuk Instalasi dan Penggunaan Manual untuk Mesin cuci Siemens IQ500. Siemens IQ500 16 halaman.
Juga untuk Siemens IQ500: Panduan Pengguna (27 halaman), Panduan Petunjuk Instalasi (20 halaman), Panduan Petunjuk Instalasi (19 halaman)
Halaman Cetak
Control panel model 2
Control panel
Explanation
Fan on/off
#
Light on/off/dimming
A
-
Reduce the fan settings
+
Increase the fan settings/intensive setting 1, 2
Boost function (short-term maximum power)
&
Fan run-on time
x
Setting the fan
Switching on the appliance
Press the
button.
#
■
The fan starts at setting
Press the + or - button to change the fan strength.
■
Switching off
Press the
#
button.
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
Press the + button when the fan is at setting
The intensive setting
is activated. Pressing the + button
2‚
again activates the intensive setting
After approx. six minutes, the electronics automatically reduce
the fan to a lower setting . If you want to end the intensive
setting before the preset time expires, press the - button until
the required fan setting is reached.
Boost function
The boost function is a short-term maximum power setting
which can be activated in any fan setting.
Press the
button. After approx. 20 seconds, the fan switches
&
back to the previously set fan setting.
Fan run-on time
Press the
button.
x
The fan continues to operate for a further 10 minutes, and
switches off automatically after this time. If the lighting is
switched on, it remains on.
Press the
button to end the fan run-on time early.
x
6
ƒ
.
.
„
.
2 ƒ
Lighting
The lighting can be switched on and off independently of the
fan.
Press the
button.
A
Setting the brightness
Press and hold the
button until the desired brightness is
A
reached.
Saturation display
When the metal mesh grease filters or the activated carbon
filter are saturated, a signal sounds for approx. 4 seconds after
the fan is switched off.
In addition, the corresponding symbol appears in the display:
Metal mesh grease filter:
■
Activated carbon filter:
■
If you have not yet done so, the metal mesh grease filters
should be cleaned or the activated carbon filter changed now.
For instructions on how to clean the metal mesh grease filters,
please refer to the section Cleaning and maintenance.
While the saturation displays are flashing, they can be reset. To
do this, press the
x
button.
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display must be
switched over accordingly:
The extractor hood must be connected and switched off.
■
Press the
and
buttons at the same time until the
#
x
■
display for starter sets for circulating-air mode or
™"
the
'"
display for CleanAir circulating air modules
lights up.
Repeatedly press the button combination to switch the
■
electronic control display back to exhaust air mode (
display).
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the
time for approx. three seconds. An acknowledgement signal
sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
!
"
#
and + at the same
!