Cisco 7906G/7911G Panduan Pengguna - Halaman 21
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon IP Cisco 7906G/7911G. Cisco 7906G/7911G 25 halaman. Unified ip phones/ for cisco unified communications manager express
Halaman Cetak
High priority (flash) call
Highest priority (flash override) or Executive Override call
Higher priority calls are displayed at the top of your call list. If you do not see an MLPP icon, the priority level of the call is
normal (routine).
Contact your system administrator for a list of corresponding precedence numbers for calls.
Note
To Make a Priority (Precedence) Call:
Enter the MLPP access number (provided by your system administrator) followed by the Precedence level (0-4) and the phone
number.
If you enter an invalid MLPP access number, a verbal announcement alerts you of the error.
Note
To answer an MLPP Call:
End an active call (if necessary) and answer the MLPP call.
If the active call has lower precedence than the incoming call then the active call is preempted.
Tips
When you are receiving a priority (precedence) call, an MLPP icon on your phone screen indicates the priority level of
–
the call.
When you make or receive an MLPP-enabled call, you hear special ring tones and call-waiting tones different from the
–
standard tones.
When you or the other party are receiving a call that must preempt the current call, disconnect immediately to allow
–
the higher priority call to ring through.
When you have more than 1 active call, the call with the lowest precedence is preempted. Similarly, for outgoing calls,
–
the call with lower precedence is preempted first.
Adjust the Volume for the Current Call
To adjust the handset, speakerphone, or headset volume for the current call:
1. During a call, press the Up or Down Volume button.
2. Press Save to apply the new volume level to future calls.
Adjust the Ring Volume
To adjust the ring volume, press the Up or Down Volume button while the handset is in its cradle.
Select the Ring Type
To change the ring type:
1. Press the Settings button.
2. Press 2 for Ring Type, or use the Navigation button to select Ring Type and press Select.
3. Use the Navigation button to select the ring type. Press the Play soft key to hear samples.
4. Highlight the ring you want, and then press Select.
5. Use one of the following options:
• Press the Ok to select your setting, which returns you to the previous menu,
21