Siemens WI12S140GB Panduan Petunjuk Pengoperasian - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mesin cuci Siemens WI12S140GB. Siemens WI12S140GB 8 halaman.

Halaman Cetak
Risk of electric shock!
Care
Maintenance
Pull out the mains plug!
Risk of explosion! No solvents!
Machine housing, control panel
- Wipe with a soft, damp cloth.
- Do not use any abrasive cloths, sponges or cleaning agents (stainless steel cleaner).
1.
- Immediately remove washing and cleaning agent residue.
- Do not clean the appliance with a water jet.
Clean the detergent drawer ...
2.
... if it contains detergent or fabric softener residue.
1.
Pull out, depress insert, completely remove.
Remove insert: Press insert upwards with finger.
2.
Clean detergent dispenser and insert with water and a brush and dry.
3.
3.
Attach insert and engage (connect cylinder to guide pin).
4.
Insert detergent drawer.
4.
Leave detergent drawer open so that residual water can evaporate.
Drum
Leave washing machine door open so that the drum can dry out.
Rust stains use chlorine free cleaning agent, not steel wool.
Descaling
No washing in the machine!
Not necessary if detergent dispensed correctly. However, follow the instructions of the descaler
manufacturer.
1.
2.
Information about the indicator lights
3.
4.
depending on model
A signal sounds and the spin speed indicator lamps and the status displays flash:
1.
Close the washing
Turn the tap on fully,
Clean detergent
machine door properly;
supply hose kinked/
solution pump ->
washing may be
jammed; Clean filter >
Page 9; outlet pipe/
caught.
Page 9; water pressure
drainage hose
too low.
blocked.
Water in the base pan,
appliance leaking. Call
Motor fault.
or
customer service!
or
2.
Call customer service!
Other displays: Switch off the appliance, wait for 5 seconds and switch it back on.
If the display appears again, call customer services > Installation instructions, Page 7.
7
8
Risk of scalding!
What to do if ...
Allow deterhgent solution to cool down!
Turn off the tap!
F
Water is running out.
Detergent solution pump
Set programme selector to Off, pull out the mains plug.
F
Water not flowing in.
Detergent not washed
Take the drainage hose out of the retainer.
in.
Remove the sealing cap, allow the detergent solution to
flow out. Push the sealing cap back on.
F
Washing machine door
cannot be opened.
Carefully unscrew the pump cover (residual water).
F
Programme does not
start.
F
Detergent solution is not
Detergent solution is not
Detergent solution is not
Detergent solution is not
Detergent solution is not
Detergent solution is not
Detergent solution is not
drained.
F
Water not visible in the
Water not visible in the
Water not visible in the
Water not visible in the
Water not visible in the
Water not visible in the
Water not visible in the
Water not visible in the
Water not visible in the
Clean the interior, pump cover thread and pump housing
drum.
(fan impeller in the detergent solution pump must rotate).
F
Spin result not
Spin result not
Spin result not
Spin result not
Spin result not
Spin result not
Spin result not
Spin result not
Spin result not
satisfactory.
satisfactory.
satisfactory.
satisfactory.
satisfactory.
satisfactory.
satisfactory.
satisfactory.
satisfactory.
Re insert pump cover and screw on tight, handle is upright.
Insert the drain hose into the holder.
F
F
F
Spin cycle actuated
Spin cycle actuated
Spin cycle actuated
Spin cycle actuated
Spin cycle actuated
Spin cycle actuated
Spin cycle actuated
Spin cycle actuated
Spin cycle actuated
several
several
several times.
several
several
several
several
times.
times.
To prevent unused detergent from flowing into the outlet during the next wash:
F
F
F
Dispenser
Dispenser
Dispenser
Dispenser
Dispenser
Dispenser
Dispenser
2
not
Pour 1 litre of water into dispenser II and start the Empty programme.
completely rinsed out.
completely
completely
F
F
F
Odour formation in the
Filter in the water inlet hose
washing machine.
Risk of electric shock!
Do not immerse Aqua Stop safety device in water
F
Foam is coming out of
(contains electric valve).
the detergent drawer.
Release water pressure in the supply hose:
Turn off the tap!
Select any programme (except Spin/Empty).
F
Intense noise formation,
Select Start/Pause. Leave programme for approx. 40 seconds.
vibrations and
Set programme selector to Off. Pull out the mains plug.
"wandering" during spin
cycle.
Clean filter:
Depending on model:
F
Indicator lights do not
Remove hose from tap.
function while the
Clean filter with small brush.
appliance is running.
F
Programme progress
longer than usual.
or
Remove hose from the rear.
F
Detergent residue on the
Remove filter with pliers and clean.
washing.
F
In the pause state
Connect the hose and check for leaks.
Start/Pause flashes very
quickly and a signal
sounds.
F
If a fault cannot be rectified or a repair is required:
- Set programme selector to Off and pull out the mains plug.
- Turn off tap and call customer service > Installation instructions, Page 7.
9
Safety instructions
- Correctly attach/replace drainage hose.
- Read and follow the operating and installation instructions and all other information enclosed
- Tighten screw fitting on the supply hose.
with the washing machine.
- Start/Pause not selected?
- Retain documents for subsequent use.
- Tap not open?
Risk of electric shock
- Never pull out the mains plug by tugging the power cord!
- Filter blocked? Clean filter -> Page 9.
- Never insert/pull out the mains plug with damp hands.
- Supply hose kinked or jammed?
Danger to life
Redundant appliances:
- Safety function active. Programme stopped? -> Page 4.
- Pull out the mains plug.
- D (Rinse stop = without final spin) selected? -> Page 4.
- Sever the power cord and discard together with the plug.
- Can be opened via emergency release only -> Page 6.
- Destroy the lock on the washing machine door.
This will prevent children from locking themselves in and
- Start/Pause selected?
suffocating.
- Washing machine door closed?
Risk of suffocation
- Keep packaging, plastic film and packaging parts out of the reach
- Clean detergent solution pump -> Page 9.
of children.
- Clean outlet pipe and/or drainage hose.
- Clean outlet pipe and/or drainage hose.
- Clean outlet pipe and/or drainage hose.
Risk of poisioning
- Keep detergents and care products out of the reach of children.
- Not a fault - water below the visible area.
Risk of explosion
- Caused by detergents containing solvents, e.g. stain
remover/items of washing pretreated with solvent naphtha may
result in an explosion after being loaded into the washing machine.
- Wash small and large items of washing together.
Before hand thoroughly rinse items of washing by hand.
- Less Ironing selected? -> Page 5.
- Too low speed selected? -> Page 3.
Risk of injury
- Washing machine door may become very hot.
- Caution when draining hot detergent solution.
- Not a fault - unbalanced load detection system adjusts
- Do not climb on the washing machine.
imbalance.
- Do not lean on the open washing machine door.
- Remove the insert. Clean detergent drawer and insert > Page 8.
- Do not touch the drum in case it is still spinning.
Consumption values
- Run Cottons/Coloureds 90 ºC programme without washing.
Use standard detergent.
- Too much detergent used?
Programme
Additonal
Mix 1 tablespoon of fabric conditioner with ½ litre of water and
function
pour into dispenser II in the detergent drawer.
Cottons/Coloureds 30 °C*
Intensive Wash
- Reduce detergent dosage for the next wash cycle.
Cottons/Coloureds 40 °C*
Intensive Wash
- Appliance feet fixed?
Cottons/Coloureds 60 °C
Intensive Wash
Secure appliance feet > Installation instructions, Page 5.
Eco 60 °C*
- Transportation safety devices removed?
Intensive Wash
Remove transportation protection devices > Installation
Cottons/Coloureds 90 °C
Intensive Wash
instructions, Page 4.
Easy Care 40 °C*
Intensive Wash
- Power failure?
Easy Care 40 °C
- Fuse tripped? Switch on/replace fuse.
-
(also suitable as Short programme)
- If the fault occurs repeatedly, call customer service.
Delicates/Silk 30 °C
-
- Not a fault - unbalanced load detection system adjusts imbalance
u Wool Cold
-
by repeatedly distributing the washing.
u Wool 30 °C
-
- Not a fault foam detection system active - a rinse cycle is
started.
* Programme setting with maximum spin speed for conducting test according to currently valid
- Occasionally phosphate free detergents contain water insoluble
European Standard 60456.
residue.
** The values deviate from the indicated values depending on water pressure, water hardness, water
- Select K (Rinse) or brush the laundry after washing.
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
- Water level too high. Top up washing is not possible.
detergent, fluctuations in the mains voltage and selected additional functions.
If required, close door immediately.
- Select "Start/Pause" to continue the programme.
10
Operating instructions
Load
Current** Water** Programme
duration**
7,0 kg 0.55 kWh
75 l
2:12 h
7,0 kg 0.85 kWh
75 l
2:12 h
7,0 kg 1,50 kWh
75 l
2:12 h
7,0 kg 1.19 kWh
49 l
2:25 h
7,0 kg 2,51 kWh
90 l
2:12 h
3,5 kg 0,55 kWh
55 l
1:12 h
3,5 kg 0.54 kWh
55 l
0:45 h
Washing
2,0 kg 0.20 kWh
39 l
0:40 h
machine
2,0 kg 0.08 kWh
47 l
0:36 h
2,0 kg 0.20 kWh
47 l
0:36 h
Read these instructions before switching on the washing machine!
Also follow the separate Installation instructions.
Follow the safety instructions on page 11!
11
en