Cisco 7925G - Unified Wireless IP Phone VoIP Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon IP Cisco 7925G - Unified Wireless IP Phone VoIP. Cisco 7925G - Unified Wireless IP Phone VoIP 28 halaman. Wavelink avalanche management console
Juga untuk Cisco 7925G - Unified Wireless IP Phone VoIP: Lembar data (8 halaman), Catatan Rilis (16 halaman), Panduan Aksesori (20 halaman), Panduan Aksesori (13 halaman), Panduan Administrasi (19 halaman), Panduan Pengguna (10 halaman), Panduan Pengguna (16 halaman), Panduan Cepat (14 halaman), Panduan Administrasi (23 halaman), Panduan Instalasi (21 halaman), Panduan Administrasi (14 halaman)

Using the USB Cable and PC Port to Charge the Battery

You can charge the battery in the phone by connecting your phone with a USB cable to a USB port on you PC. Charging takes

longer when you use the USB port on the PC to charge the battery.

To use the USB cable and USB port to charge the battery, use this diagram and follow the steps:

D E F

ABC

M N O

G H I

JKL

P Q R S

W X Y

TUV

Charge the Battery using the USB Cable

1. Insert the phone connector on the USB cable into the phone.

2. Insert the USB A-type connector into the USB port on your PC.

Note

If the Found New Hardware Wizard opens, use the following procedure to stop it.

3. Monitor the indicator light after the phone briefly displays "USB Connected" on the status line.

While the battery is charging, the indicator light is red. When the battery is fully charged, the indicator light turns green.

Stop Found New Hardware Wizard from Opening when Connecting to USB Port

1. Click Next to use the wizard dialog box.

2. In the Update New Software dialog, click No, not this time, and click Next.

3. Click Install the Software automatically (Recommended) and click Next.

4. After a few moments, the Cannot Install This Hardware dialog displays. Click Don't prompt me again to install this

software.

5. Click Finish to close the dialog box.

Powering On the Phone

After charging the battery, you must power on the phone to make and receive calls.

1. Press and hold the

(red button) until the phone powers on.