Siemens dishwasher Panduan Petunjuk Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mesin pencuci piring Siemens dishwasher. Siemens dishwasher 30 halaman. Dishwasher
Juga untuk Siemens dishwasher: Petunjuk Penggunaan Manual (29 halaman), Panduan Petunjuk Pengoperasian (30 halaman), Panduan Petunjuk Pengoperasian (30 halaman), Panduan Petunjuk Pengoperasian (28 halaman), Panduan Petunjuk Pengoperasian (26 halaman), Petunjuk Penggunaan Manual (28 halaman), Petunjuk Penggunaan Manual (26 halaman), Petunjuk Penggunaan Manual (28 halaman), Petunjuk Penggunaan Manual (32 halaman), Petunjuk Penggunaan Manual (28 halaman), Petunjuk Penggunaan Manual (34 halaman), Petunjuk Penggunaan Manual (34 halaman), Petunjuk Penggunaan Manual (28 halaman), Petunjuk Penggunaan Manual (34 halaman), Petunjuk Penggunaan Manual (26 halaman), Panduan Petunjuk Pengoperasian (40 halaman), Petunjuk Penggunaan Manual (31 halaman), Petunjuk Penggunaan Manual (40 halaman), Panduan Petunjuk Pengoperasian (24 halaman), Panduan Petunjuk Pengoperasian (28 halaman), Panduan Petunjuk Pengoperasian (28 halaman)

Halaman Cetak
Siemens dishwasher Panduan Petunjuk Pengoperasian
en

Water softening system

To ensure good washing results, the
dishwasher requires soft water, i.e.
containing low amounts of lime, otherwise
white limescale will be deposited on the
utensils and inner container.
Tap water above 9° Clarke must be
softened. The water is softened with salt
(regeneration salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree of
hardness of your tap water (see table).

Setting

The amount of salt dispensed can be set
from
:
to :
Salt is not required at the set value
– Find out about the hardness value of
your tap water. Your water utility
company will help you with this.
– Set value can be found in the water
hardness table.
– Open the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button ` until : .... is
indicated on the digital display.
– Release both buttons.
The LED for button # flashes and the
digital display h displays the factory
setting :
.
To change the setting:
– Press programme button 3.
Each time the button is pressed, the
set value increases by one level; when
the value of :
the display jumps back to :
– Press START button `.
The chosen setting has now been
stored.
– Close the door.
6
.
has been reached,
(off).

Water hardness table

:DWHU
KDUGQHVV
YDOXH
ƒ&ODUNH
:
.
+DUGQHVV
PPROO
UDQJH
VRIW
VRIW
PHGLXP
PHGLXP
PHGLXP
KDUG
KDUG
KDUG
6HW YDOXH
RQ WKH
PDFKLQH
‡¯¯
‡¯³
‡¯›
‡¯´
‡¯ž
‡¯‚
‡¯±
‡¯Å