Siemens SK Series Petunjuk Pengoperasian - Halaman 29

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Mesin pencuci piring Siemens SK Series. Siemens SK Series 36 halaman.

Halaman Cetak
Fault
Coloured (yellow, orange,
brown), easily removable
deposits inside
the appliance (mainly
in the floor area).
Plastic parts discoloured.
Removable streaks on
glasses, glasses with
metallic appearance and
cutlery.
Initial or existing,
irreversible clouding
of glass.
Cause
Film formation consisting
of ingredients from food
remnants and substances from
the tap water (limescale), "soapy"
Too low rinsing temperature.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Too much rinse aid.
No rinse aid added or setting too
low.
Detergent residue in the final
rinse programme section.
Detergent dispenser cover
blocked by utensils (cover does
not open fully).
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Glasses not dishwasher-proof,
only suitable for dishwasher.
Fault, what to do?
Remedial action
Check function of the water softening
system (refill with salt) or, if using combined
detergents (tablets), activate water
softening system (see chapter Water
softening system/Special salt).
Select programme with higher washing
temperature.
Do not prerinse utensils. Remove only large
food remnants.
Recommended programme Eco 50°
Set rinse aid amount to lower setting.
Add rinse aid and check dosage
(recommended setting 4-5).
Detergent dispenser cover must not be
obstructed by utensils.
Do not prerinse utensils. Remove only large
food remnants.
Recommended programme Eco 50°
Use dishwasher-proof glasses.
Avoid long steam phase (standing time after
wash cycle ends).
Use wash cycle at lower temperature.
Set water softening system according to the
water hardness (if required one setting
lower).
Use detergent with glass protection
component.
en
29