Siemens SX Series Petunjuk Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Mesin pencuci piring Siemens SX Series. Siemens SX Series 38 halaman. Dishwasher
Juga untuk Siemens SX Series: Panduan Petunjuk Pengoperasian (38 halaman), Panduan Petunjuk Pengoperasian (42 halaman), Panduan Petunjuk Pengoperasian (42 halaman), Panduan Petunjuk Pengoperasian (44 halaman), Panduan Petunjuk Pengoperasian (46 halaman), Panduan Petunjuk Pengoperasian (44 halaman), Panduan Petunjuk Pengoperasian (42 halaman), Buku Petunjuk (48 halaman), Panduan Petunjuk Pengoperasian (40 halaman), Panduan Petunjuk Pengoperasian (42 halaman), Panduan Petunjuk Pengoperasian (44 halaman), Panduan Petunjuk Pengoperasian (40 halaman)

Halaman Cetak
Siemens SX Series Petunjuk Pengoperasian

Appliance interior

1" Top basket
1* Knife shelf *
12 Tablet collecting tray
1: Upper spray arms
1B Bottom spray arm
1J Dispenser for special salt
1R Filters
1Z Cutlery basket
1b Bottom basket
1j Dispenser for rinse aid
9" Detergent dispenser
9* Lock for detergent dispenser
92 Rating plate
* depending on model
Water softening
system/Special salt
s a l t
e m / S p e c i a l
n g s y s t
s o f t e n i
W a t e r
To ensure good washing results,
the dishwasher requires soft water, i.e.
containing low amounts of lime,
otherwise white limescale will be
deposited on the utensils and inner
container.
Tap water above a specific
degree of water hardness must be
softened, i.e. descaled,
for use in a dishwasher. Water
is softened with special salt in the water
softening system of the dishwasher.
The setting and therefore the required
amount of salt
depends on the degree of hardness of
your tap water (see table).

Water softening system/Special salt

Setting

The amount of salt dispensed can be
set in 4 stages
depending on the hardness of your
water. Accordingly 0, 1, 2 or 3 displays
are lit (see table). Factory setting: 1.
1. Find out about the hardness
value of your tap water. Your water
utility company will help you with this.
2. Setting can be found in the water
hardness table.
3. Open the door.
4. Switch on ON/OFF switch (.
5. Hold down button > P and press
START button h until the dry
display ` and salt refill
indicator )* flash.
6. Release buttons.
The salt refill indicator )* flashes
and the display # is lit
(= Setting 1).
To change the setting:
1. Press the button < H until
the required setting has been
selected.
2. Press START button h.
The displays ` and )* go out.
The selected setting is saved.
3. Close the door.
en
9