Siemens SX Series Panduan Petunjuk Pengoperasian - Halaman 36

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mesin pencuci piring Siemens SX Series. Siemens SX Series 44 halaman. Dishwasher
Juga untuk Siemens SX Series: Petunjuk Pengoperasian (38 halaman), Panduan Petunjuk Pengoperasian (38 halaman), Panduan Petunjuk Pengoperasian (42 halaman), Panduan Petunjuk Pengoperasian (42 halaman), Panduan Petunjuk Pengoperasian (46 halaman), Panduan Petunjuk Pengoperasian (44 halaman), Panduan Petunjuk Pengoperasian (42 halaman), Buku Petunjuk (48 halaman), Panduan Petunjuk Pengoperasian (40 halaman), Panduan Petunjuk Pengoperasian (42 halaman), Panduan Petunjuk Pengoperasian (44 halaman), Panduan Petunjuk Pengoperasian (40 halaman)

Halaman Cetak
Siemens SX Series Panduan Petunjuk Pengoperasian
en
Fault, what to do?
Fault
Initial or existing,
irreversible clouding of
glass.
Rust spots on the cutlery.
Appliance does not start.
Programme starts
automatically.
The door is difficult to
open.
Door cannot be closed.
Cover on the detergent
dispenser cannot be
closed.
36
Cause
Glasses not dishwasher-proof,
only suitable for dishwasher.
Cutlery not adequately rust-
resistant. Knife blades are
frequently more severely
affected.
Cutlery will also rust if rusting
parts are rinsed at the same time
(pan handles, damaged utensil
baskets, etc.).
Salt content in the rinsing water
too high, as salt dispenser lock
not fastened firmly or salt was
spilled while being refilled.
The mains fuse has tripped.
Power cord not inserted.
The appliance door has not been
shut properly.
You did not wait until programme
ended.
Child lock is activated.
Door lock has been activated.
Door cannot be closed due to
installation.
Detergent dispenser or cover
guide blocked by sticky detergent
residue.
Remedial action
Use dishwasher-proof glasses.
Avoid long steam phase (standing time after
wash cycle ends).
Use wash cycle at lower temperature.
Set water softening system according to the
water hardness (if required one setting
lower).
Use detergent with glass protection
component.
Use corrosion-resistant cutlery.
Do not wash rusting parts.
Fasten salt dispenser lock firmly or remove
spilled salt.
Check mains fuse.
Ensure that the power cord is plugged all
the way into the back of the appliance and
into the socket. Check that the socket
functions.
Close the door.
Perform reset.
(See "Terminating the programme").
Deactivate child lock. (See instructions for
use at the back)
Close door with increased force.
Check appliance installation: Door
or attached parts must close without
obstruction.
Remove detergent residue.