Siemens BFA1 Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Siemens BFA1. Siemens BFA1 12 halaman.
Halaman Cetak
en Disposal
Fault
and the heat setting flash al-
ternately. A signal sounds.
and audible signal
and hotplates do not heat up
A message with "E" appears on
the display, e.g. E0111.
11 Disposal
Find out here how to dispose of old appliances cor-
rectly.
11.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
Dispose of the appliance in an environmentally
▶
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
10
Cause and troubleshooting
Several hotplates have been used over a prolonged period at high power set-
tings. The hotplate has been switched off to protect the electronics.
Wait a while.
1.
Touch any touch field.
2.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue to cook.
Despite being switched off by
hotplates have therefore been switched off.
Wait a while.
1.
2.
Touch any touch field.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue to cook.
Hot pot near the control panel. There is a risk that the electronics will overheat.
Remove the pan.
▶
a The display goes out shortly afterwards.
Hot pot near the control panel. The hotplate has been switched off to protect the
electronics.
Remove the pot.
1.
Wait a while.
2.
3.
Touch any touch field.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue to cook.
The hotplate was on for too long and has switched off automatically.
You can switch the hotplate back on again immediately.
Demo mode is activated.
Disconnect the appliance from the power supply for 30 seconds by briefly
1.
switching off the circuit breaker in the fuse box.
2.
Touch any touch field within the next three minutes.
The electronics have detected a fault.
Switch the appliance off and on again.
1.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the
2.
exact error message when calling.
→ "Customer Service", Page 11
, the electronics have become hot again. All
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.