Epson BrightLink 480i Buku Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Buku Panduan Instalasi untuk Proyektor Epson BrightLink 480i. Epson BrightLink 480i 2 halaman. Lamp and status information
Juga untuk Epson BrightLink 480i: Mulai dari Sini Manual (6 halaman), Panduan Pengoperasian (47 halaman), Manual Koneksi (6 halaman), Panduan Instalasi (5 halaman), Template Pemasangan (5 halaman), Spesifikasi (6 halaman), Pernyataan Kesesuaian (4 halaman), Buku Panduan Instalasi (3 halaman), Buku Panduan Instalasi (5 halaman), Mulai dari Sini Manual (6 halaman)

Halaman Cetak
Epson BrightLink 480i Buku Panduan Instalasi
Epson BrightLink 475Wi / 480i / 485Wi
Power light
Red
Red
Varies
Red
Varies
Red or flashing
red
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.
Lamp light
Temperature
light
Off
Red
Flashing red
Off
Flashing
Off
orange
Off
Flashing red
Flashing
Flashing orange
orange
Flashing red
Flashing red
INSTALLATION HANDBOOK
Status and solution
Projector has overheated and turned off. Leave it
turned off to cool down for five minutes.
• Make sure that the vents and air filter are not
clogged with dust or obstructed by nearby
objects.
• If operating the projector at high altitude, turn on
High Altitude Mode.
• If overheating continues, replace the air filter.
• If the problem persists, unplug the projector and
contact Epson for help.
Lamp has a problem.
• Check to see if the lamp is burned out, broken,
or installed incorrectly. Reseat or replace the
lamp as necessary.
• Make sure that the vents and air filter are not
clogged with dust or obstructed by nearby
objects.
• If operating the projector at high altitude, turn on
High Altitude Mode.
• If the problem persists, unplug the projector and
contact Epson for help.
Replace the lamp soon to avoid damage. Do not
continue using the projector.
A fan or sensor has a problem. Turn the projector
off, unplug it, and contact Epson for help.
An obstacle has been detected around the
projection window. Remove the obstacle, or clean
the obstacle sensors. If the problem persists,
unplug the projector and contact Epson for help.
Internal projector error. Turn the projector off,
unplug it, and contact Epson for help.
Lamp and Status Information
2