Siemens EC9A5RB90A Petunjuk Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Kompor Siemens EC9A5RB90A. Siemens EC9A5RB90A 20 halaman. 90 cm gas cooktop
Juga untuk Siemens EC9A5RB90A: Petunjuk Pengguna (20 halaman)

Halaman Cetak

This appliance must be earthed. When connecting

■

the cooktop ensure that the earth wire is connected

first and that all wires are connected to the correct

terminals.

Wiring diagram

Switch

Blue wire

Brown wire

Terminal

Ignition module

Gas connection

During the planning stage, consider the position of

supply connections.

The cooktop must be connected to the gas supply with

upstream connection of an isolation valve in

accordance with the respectively valid regulations. We

recommend that the isolation valve be fitted prior to the

cooktop to enable isolation of cooktop from gas supply.

The valve must be easily accessible at all times.

To find out the factory set gas type, see bottom of

cooktop next to gas connection.

Remove plastic cap from gas supply line prior to

installation.

Installation and connection

Fit regulator (N.G.) or a test point (Universal LPG)

directly to the R 1/2'' connection.

Direction of gas flow is indicated on the rear of the

regulator.

Position of the inlet connection:

Use pipe compound or thread sealant, properly

threaded pipes and careful assembly procedure so that

there is no cross threading, etc., which might cause

damage or leakage.

Make sure that all connections performed are free of

leakage. The manufacturer does not accept any liability

for leakage on connections performed by the installer or

if the L-tube is moved or twisted.

There are two ways to carry out the connection to the

main gas line:

The hotplate can be connected with rigid pipe as

■

specified in AS/NZS 5601.1

Flexible Hose: If installing with a hose assembly, it

■

must comply with AS/NZS 1869, 10 mm ID, class B

or D, no more than 1.2 m long and installed in

accordance with AS/NZS 5601.1.

Ensure that the hose does not contact the hot

surfaces of the hotplate, oven, dishwasher or any

other appliance that may be installed underneath or

next to the hotplate. The hose should not be

subjected to abrasion, kinking or permanent

deformation and should be able to be inspected

along its entire length with the cooktop in the

installed position. Unions compatible with the hose

fittings must be used and all connections tested for

gas leaks.

The supply connection point shall be accessible with

the appliance installed.

WARNING: Ensure that the hose assembly is restrained

from accidental contact with the flue outlet of an

underbench oven.

Before Leaving

Check all connections for gas leaks with soap and

water. DO NOT use a naked flame for detecting leaks.