Siemens EH8..ML1.. Buku Petunjuk - Halaman 14

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kompor Siemens EH8..ML1... Siemens EH8..ML1.. 16 halaman.

Halaman Cetak

Care and cleaning

The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition

Hob

Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cold enough
before attempting to clean it.
Only use cleaning products specifically designed for glass-
ceramic hobs. Follow the instructions provided on the
packaging.
Do not use:
Abrasive products
■
heavy-duty cleaners, like oven sprays and stain removers
■
Pads that may scratch
■
High-pressure or steam cleaners
■

Fixing malfunctions

Malfunctions are generally caused by minor faults. Before
contacting the Technical Assistance Service, make sure you
have read the following recommendations and warnings.
Indicator
Malfunction
none
The electric power supply has been
interrupted.
The appliance has not been correctly
connected following the connection
diagram.
Electronic system malfunction.
The control panel is wet or an object is
flashing
"
resting on it.
Electronic system malfunction.
+ number /
"§
š
+ number /
+ number
¡
There is an internal error in the system.
"‹
/
"Š
The electronic system has overheated and
"ƒ
the corresponding hotplate has been
switched off.
The electronic system has overheated and
"...
all hotplates have been switched off.
Supply voltage outside normal operating
—‚
limits.
The hotplate has overheated and switched
/
—ƒ
—„
off to protect its working surface.
* If the warning persists call the Technical Assistance Service.
Do not place hot pans on the control panel.
14
Glass scraper
Remove dried-on food remains using a glass scraper.
Release the scraper safety catch
1.
Use the blade to clean the hob surface
2.
Do not attempt to clean the hob surface with the base of the
scraper. This could result in scratching.
ã=
Risk of injury!!
The blade is extremely sharp. Risk of cuts. Protect the blade
when not in use. Replace the blade immediately when any
imperfections are found.
Care of the appliance
Apply an additive to protect and preserve the hob. Follow the
advice and warnings provided with the product.

Hob frame

In order to avoid damage to the hob frame, follow the
indications below:
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
■
Measure
Use other electrical appliances to check if there has been a power
cut.
Make sure that the appliance has been connected correctly.
If in the above checks, the malfunction is not resolved, contact the
Technical Assistance Service.
Dry the control panel area or remove the object.
Disconnect the hob from the mains. Wait 30 seconds or so, then
connect it again.*
Disconnect the hob from the mains. Wait 30 seconds or so, then
connect it again.*
Wait until the electronic system has cooled down completely. Then
press any symbol on the hob.*
Please contact the local electricity board.
Wait until the electronic system has cooled down sufficiently before
switching it back on.