Cisco 8811 Manual - Halaman 32

Jelajahi secara online atau unduh pdf Manual untuk Telepon IP Cisco 8811. Cisco 8811 48 halaman. Calltower vpn enabled phone
Juga untuk Cisco 8811: Panduan Pengguna (16 halaman), Fitur (16 halaman), Panduan Memulai dengan Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (24 halaman), Panduan Pengguna (28 halaman), Panduan Utama Migrasi Firmware (31 halaman), Panduan Pengguna (30 halaman), Manual (44 halaman), Panduan Memulai Cepat (2 halaman), Panduan Konfigurasi Ulang (2 halaman), Tembak Masalah (4 halaman), Panduan Referensi Cepat (2 halaman), Panduan Memulai Cepat (2 halaman), Manual (22 halaman), Memulai (2 halaman), Panduan Memulai Cepat (2 halaman), Mulai Cepat (2 halaman)

Troubleshoot the Key Expansion Module

• For MWI + speed dial + DTMF:

For more information about the string syntax, see

You can also configure this parameter in the phone configuration file (cfg.xml). The parameter is line-specific.

Enter a string in this format:

<Unit_1_Key_1_ ua="na">fnc=mwi+sd;ext=8000 ,4085283300#,123456#@domain;

sub=group_vm@domain;vid=1;nme=Group;</Unit_1_Key_1_>

Step 4

In the General section, add

Parameter in the configuration file (cfg.xml):

<Customizable_PLK_Options ua="na">mwi;sd</Customizable_PLK_Options>

After the configuration, users can configure the corresponding features on the expansion module button.

Step 5

Click Submit All Changes.

Troubleshoot the Key Expansion Module

Procedure

Step 1

Open a CLI.

Step 2

Enter the following command to enter debug mode:

debugsh

Step 3

Enter ? to see all available commands and options.

Step 4

Use the applicable commands and options to find the desired information.

Step 5

To exit debug mode, press Ctrl-C.

Key Expansion Module Does Not Go Through the Normal Start Up Process

Problem

When you connect a key expansion module to a phone that is connected to a network port, the key expansion

module doesn't start up.

Cause

• Key expansion module type and the attached key expansion module don't match.

• The phone has more than one type of expansion module connected.

• Power over Ethernet (PoE) doesn't meet the required power-supply.

• Connected number of key expansion modules exceed maximum "Number of Units".

Cisco IP Phone Accessories

fnc=mwi+sd;ext=8000 ,4085283300#,123456#@domain;sub=group_vm@domain;vid=1;nme=Group;

mwi

String Syntax for Voicemail

in the field Customizable PLK Options.

mwi;sd

Cisco IP Phone Accessories

PLK.