Cisco SPA 303 Series Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon IP Cisco SPA 303 Series. Cisco SPA 303 Series 6 halaman. Cisco small business spa300 / spa500 series
Juga untuk Cisco SPA 303 Series: Panduan Memulai Cepat (2 halaman), Lembar data (7 halaman), Panduan Pengaturan dan Pemecahan Masalah (11 halaman), Panduan Memulai Cepat (5 halaman), Panduan Memulai Cepat (6 halaman), Panduan Memulai Cepat (18 halaman), Panduan Pengguna Cepat (2 halaman), Panduan Pengguna (12 halaman), Panduan Memulai Cepat (2 halaman)

Placing Outbound Calls

You can make outbound calls by simply dialing the destination telephone number. For those who have a

10 digit US/Canada number in addition to 4 digit extension number their selection (pressing) of 'green'

line button next to the extension number will display company's business telephone number to the call

recipient. On the other hand selection (pressing) of 'green' line button next to the 10 digit number will

display that number to the call recipient

Ending a Call

To end a call:

• If you are using the handset, just hang up.

• If you are using the speakerphone, press the Speaker button.

• If you are using a headset, either press the Headset button (wired) or replace the receiver (when using

certain wireless models).

Ignoring an Incoming Call:

• When call lands press 'Ignore' soft-key button.

Transferring a Call

You can perform following types of transfers:

Performing an Attended Transfer

• Attended Transfer:

- transfer the call while the phone is ringing.

- wait for the person to answer before transferring the call.

STEP 1 - During an active call, press 'xfer' soft-key. The call is placed on hold and a new line is opened to

dial the number where the call in intended to be transferred.

STEP 2 Either:

• Enter the number to which you want to transfer the call, then press the 'dial' soft-key or wait a few

seconds.

• Press the 'dir' soft-key and either choose a number from the personal directory or select the

Corporate Directory, then press the 'dial' soft-key.