Ricoh SP C262SFNw Setup Manual - Halaman 9
Jelajahi secara online atau unduh pdf Setup Manual untuk Semua dalam Satu Printer Ricoh SP C262SFNw. Ricoh SP C262SFNw 17 halaman.
Halaman Cetak
- 1. Setup Guide
- 2. Setting up the Machine
- 3. Installing the Software
- 4. Check How the Computer Is Connected
- 5. Connecting the Machine (Usb/Network)
- 6. Connecting the Machine Via Wi-Fi
- 7. Fax Settings
- 8. Selecting the Telephone Line Type and Telephone Network Connection Type
- 9. Setting the Outside Line Access Number
- 10. Basic Operation for Sending a Fax
- 11. Scan Settings
- 12. Control Panel Sheet
Easy Setup Using the Wi-Fi Setup Wizard
The following item is necessary to set up a wireless
connection.
● Router (access point)
Checking the SSID and Encryption key
The SSID and Encryption key for the router (access point) may be
printed on a label affixed to the router (access point). For details
about the SSID and Encryption key, refer to the router (access point)
manual.
Confirm the SSID and Encryption key, and write them down on the
blank space as shown below.
SSID:
Encryption key:
Configuring Settings Using the Control Panel
● Before doing the following procedure, install the printer
driver according to the procedure on page 5
"Connecting the Machine (USB/Network)".
● Make sure the Ethernet cable is not connected to the
machine.
1.
Check that the router (access point) is working correctly.
2.
Press [Setting].
3.
Press [Network Settings].
4.
If you are requested to enter a password, enter the
password using the number keys, and then press [OK].
A password for accessing the [Network Settings] menu can be
specified in [Admin. Tools Lock] under [Administrator Tools]
menu.
SSID
:XXXXXXXXXXXXX
Encryption key
:XXXXXXXXXXXXX
DSG099
5.
Press [Wi-Fi Enable].
6.
Press [Enable].
7.
Turn off the machine, and then turn it back on.
8.
Press the wireless LAN icon.
9.
Press [Setup Wizard].
10. If you are requested to enter a password, enter the
password using the number keys, and then press [OK].
A password for accessing the [Wi-Fi Configuration] menu can
be specified in [Admin. Tools Lock] under [Administrator Tools]
menu.
11. Press the SSID of the router (access point) from the
searched SSID list.
12. Enter the encryption key using the number keys, and then
press [Connect].
• As the passphrase, you can enter either 8 to 63 ASCII characters
(0x20-0x7e) or 64 hexadecimal digits (0-9, A-F, a-f).
• For details about checking the encryption key, see "Checking the
SSID and Encryption key".
13. Check the result.
Connection has succeeded:
"Connected to access point." is displayed.
Connection has failed:
"Failed to connect to access point." is displayed.
Check the configuration for the router (access point), and then try the
connection again.
14. Configuring the Wi-Fi settings is complete.
7