Cisco SPA232D Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon IP Cisco SPA232D. Cisco SPA232D 10 halaman. Ip dect handset
Juga untuk Cisco SPA232D: Panduan Memulai Cepat (17 halaman)
Halaman Cetak
Note 1: To verify that the handset is registered to the base station, confirm that the DECT signal strength icon is
solid (not flashing) and that the handset ID, such as Handset 1 (or Handset 2), appears near the top right corner
of the display screen.
Note2: In case that the batteries are removed from the handset or go dead, the handset will still be registered on
the base station.
7.0 Upgrade the SPA 302D handset software
It is possible to manually upgrade the handset to the latest software version. Software upgrades are performed
"over the air" and the Cisco SPA232D does not have an external interface requiring a physical connection to
another device.
From the Settings menu choose Update Software and then, at the Check for software update prompt press
Confirm.
Within a moment, the handset displays the current version of software on the handset and the latest software
version available from the Cisco SPA232D. Press the Select soft key.
Place the handset in the charging cradle (Important: Do not remove the handset from the charging cradle
during the upgrade. Do not power off the handset, charging cradle, or base station, or otherwise interrupt the
upgrade process).
The handset erases the flash memory, downloads the new software and verifies the upgrade data. After the
upgrade, a message appears indicating the status of the upgrade (for example, if the upgrade succeeded).
Press Reset to reboot the handset.
Note 1: If the upgrade fails, press Reset to reboot the handset. Check the status lights on the Cisco SPA232D
to make sure the unit is powered on and functioning. Repeat the upgrade.
Note 2: If the handset has a software version less than 2.55 (i.e. either 2.40 or 2.50) this process needs to be
manually performed by the end user. In subsequent firmware releases and if the handset already has the
2.62 firmware version installed, it will be able to upgrade its software version automatically once it is
associated with the base station.
Cisco SPA302D and SPA232D full user guide v1.0