Ricoh Aficio MP 3350 Panduan Pengguna - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Printer Ricoh Aficio MP 3350. Ricoh Aficio MP 3350 41 halaman. Sap printing
Juga untuk Ricoh Aficio MP 3350: Brosur & Spesifikasi (6 halaman), Manual (12 halaman)

Halaman Cetak

PaperCut – Ricoh Embedded Manual

2.2.12 Set Default Application and System Timeout

The PaperCut embedded application is now installed on the Ricoh MFP device. For the

PaperCut embedded application to run effectively it must be configured as the default

application and a system reset timeout should be set. This gives PaperCut full control of the

copier and forces the user to login before using the copier.

To do this:

1. On the device go to the Ricoh admin/settings by pressing the "User Tools/Counter"

hard key (on the top left of the device panel).

2. Press the "System Settings" button.

3. On the "General Features" tab, select the "Function Priority" setting.

4. Select "JavaTM/X" and press "OK". For SDK 10.x+ devices, see Extended Features,

then PaperCut MF.

5. Select the "Timer Settings" tab.

6. Select the "System Auto Reset Timer" option.

7. Enable the timer by pressing the "On" button and set the timeout to something

reasonable. We recommend setting this to between 30 and 60 seconds. There is a

trade-off setting the timeout. If it is set too short, then it will be annoying for users. If

it is set too long and users forget to logout other users could charge copies to the

previous user's account.

2.2.13 Starting the Embedded Application

Once the application is installed and configured it can be started via the web interface.

Navigate to Device Configuration->Extended Feature Settings->Startup Setting.

Alternatively, the embedded application can be started at the device itself.

1. Go to the Ricoh admin/settings by pressing the "User Tools/Counter" hard key (on

the left of the device panel).

2. Press the "Extended Feature Settings" button at the bottom of the screen.

3. On the "Extended Features Settings" screen, select the "Startup Setting" tab.

4. The running applications are highlighted. To start the PaperCut application, press

the "PaperCut MF" application button.

5. The device will display a "Please wait ..." dialog until the application starts.

6. Once started, exit the admin screens by pressing Exit twice.

7. Press the "Other function" hard button (which is below the copy/fax buttons on the

left – this can also be replaced with a custom button). The PaperCut application will

then appear as shown below. On SDK 10.x+ devices, the PaperCut application can

be found after pressing the 'Home' hardware button.

8. The first time the PaperCut application runs, it prompts for a friendly name to register

the device in PaperCut (e.g. admin-copier). The name should uniquely identify the

device on your network. Using the same name as the copier's print queue is

recommended. Enter the name and press "Save".

Revision: 19

2012-10-26

16 of 41